FS: Enthuza axle back muffler.
 

hey guys i found this stored in my garage. its an old enthuza exhaust i bought a long time ago from Chelsea (ienjoydrifting).

i used to be a full exhaust (it was basically a straight pipe with a resonator and a flange on the end for the cat).

but i ended up using the other end to make a custom exhaust.

i was left with this muffler which is in great shape and sounds awesome. inlet i believe is 2.5. i have to double check. the exit is a 3in and looks awesome in the back of a miata...all hangers work perfect and will be included and line this puppy up perfectly with the factory whole. i dont see it being too dificult to fab up the rest of the exhuast since its a fairly straight section of the car.

i don't really know how much to ask but i guess $125 shipped?

Attachment 192238
Attachment 192239
Attachment 192240


thank you for looking :)

Can you please verify inlet and outlet diameters? Looks like the outlet is larger, but I may be interested if the inlet is 3". And where are you located?

Jason never welded tips on the full 3" exhausts...so it's probably 2.5" inlet and 3" outlet.

Notice how the inlet pipe swags out at the muffler, but the outlet pipe doesn't. Looks to be an ANSA muffler.

Mine has tips.

No swage though- has a flange

the inlet is for a fact NOT 3inches. but the tip is. the inlet seems to be 2.5 but i am going to verify as soon as i get home.

ok so i got 2.5in for the inlet. i measured it and i got 6.3cm which is like 2.480in

bump!