Baller ABS door skins
#1
Elite Member
Thread Starter
iTrader: (12)
Join Date: Apr 2008
Location: Springfield IL
Posts: 2,712
Total Cats: 25
Baller ABS door skins
Built 2 sets. First set is on my car. You can buy the other.
Home built. They fit my car. You might need to pull out the dremel or drill though. I left the window crank hole small in case you had power windows. Also comes with the door pulls. Not building any more of these. Such a PITA.
85 shipped within the 48 states.
*WILL TRADE FOR DECENT DIGITAL CAMERA*
Home built. They fit my car. You might need to pull out the dremel or drill though. I left the window crank hole small in case you had power windows. Also comes with the door pulls. Not building any more of these. Such a PITA.
85 shipped within the 48 states.
*WILL TRADE FOR DECENT DIGITAL CAMERA*
Last edited by chpmnsws6; 07-12-2012 at 08:27 PM.
#5
I'm just concerned that the overall craftsmanship of this piece may not be up to the stringent specifications of my exquisite chariot.
#6
Elite Member
Thread Starter
iTrader: (12)
Join Date: Apr 2008
Location: Springfield IL
Posts: 2,712
Total Cats: 25
Sorry, the "camera" can't take them without being a mass of crappy blur. Seriously.
The edges aren't bad. If they are too rough, you can always add door trim to them.
*edit* if your talking about the bottom corner, that was before cleaning the edges up at all. I was checking fitment and tired of cleaning the edges just to do it again in 5 minutes.
The edges aren't bad. If they are too rough, you can always add door trim to them.
*edit* if your talking about the bottom corner, that was before cleaning the edges up at all. I was checking fitment and tired of cleaning the edges just to do it again in 5 minutes.
Thread
Thread Starter
Forum
Replies
Last Post
russian
Miata parts for sale/trade
6
10-08-2015 03:01 PM