FS: MS3Pro with DIYBOB 90-00 harness.
1 Attachment(s)
Just as the title says. MS3Pro with harness using the diybob for a connector.
MAP Sensor is built into the DIYBOB. It's wired for a 90-93 but I could alter it for your install. If it's for a 99-00, I'd have to remove the MAP sensor. This retails for $1,300. Although the wiring harness has been cut down to about 36". https://www.miataturbo.net/attachmen...ine=1384778067 $900 shipped. |
pic added.
|
I'm ignorant on ms3 but would this be pnp with a 94? Or could it be with your services?.
|
I'd just have to move a few wires in the harness.
|
Could you make it PNP for an 05 MSM??
|
I have an 05 connector, but I wouldn't want to really hack up the current diybob to do that.
|
From what I read, the MS3 pro is basically an MS3 with expansion board in a fancy case with nice connectors, right? Are there any differences other than that between the pro vs normal DIY MS3?
|
It's an off-the-shelf "Pro" ECU.
it's a stamped MS3 + Expander + Real Time Clock + Knock Module + SD card in a water proof case. No modding, soldering, or anything DIY. |
mineminemine.
|
All times are GMT -4. The time now is 09:49 AM. |
© 2024 MH Sub I, LLC dba Internet Brands