FS: MS3x with all the fixin's, spare 3.0 main board, DIYbob, 01-05 jumper harness, ++
 

Putting a feeler out there.

I have a MS3x that I built a couple years back that I have since upgraded to a fresh 3.0 main board. ($650 value)

It has:

• Knock Board ($85 value)
• Alternator Control (supported via software, hardware board included for free if you want to add it)
• Battery Back up ($65 or so value)
• MapDaddy Dual MAP and barometric pressure sensors

I am including:

• 70% built DIYbob for an 01-05 Miata. Includes 10' pre-labled wires from DIY. Some of the wires have been soldered to the break out box already. From DIY this costs $180.
• 22 position connector that works in one of the unused spots on the DIYbob. This will allow you to bring channels into the megasquirt via the DIYbob rather than through a separate PC style connector (like the DB37 for example) such as boost control or extra sensors and it makes for a very clean install.
• A 12" or so long jumper harness that is ready to run the car as it sits.
• A spare 3.0 board (with installed "MapDaddy dual Map sensors) but it has a couple burned out circuits that don't impact the function of the megasquirt (figure about $150 to populate a new board)

All together this looks like about a $1,100 value new but since it's not new anymore I figure I would ask $950(obo) for it all.

TL;DR: All the functionality of a MSproPnP in a slightly less convenient package for $250 less.

Pretty good deal. GLWS!!!!

Thanks. Really it all comes down to me wanting the simplicity of a MSproPnP on one of those nifty Singular ECU brackets. I am tired of having to fabricate stuff on my own and I am just ready to hit the "easy" button.