FS: Two gauge mounting options and PNP RX-7 460cc injectors
 

I've changed my mind on a couple things since starting to accumulate parts for my build. Now I need to sell some of these extras so I can keep buying more parts that I actually need.

1. RX-7 460cc injectors - These are high impedance (aka Red Top #195500-2010) PNP for your miata. I bought these off a forum member with the intent to get them cleaned and flow tested, but have since decided to go with 550cc injectors. SOLD!!!

2. Dual A-pillar mounted gauge pod. Not new, but pretty decent shape. I don't have any mounting hardware. $25 shipped.

3. NB HVAC retrofit parts - this is a method I saw over on m.net. Basically you remove the NA HVAC controls and fab your own gauge plate to go in that spot. Then you install the NB HVAC controls either above or below the radio.

I already purchased a used NB HVAC panel and NB pigtail to make wiring it easier. The HVAC panel includes the cables which fit perfectly in the NA. $50 shipped for the HVAC controls and pigtail.

This is the thread on how to do the swap:
NB HVAC controls INSTALLED in NA - MX-5 Miata Forum

The end product should look something like this:
http://forum.miata.net/vb/attachment...4&d=1222794606

I'll pick up those injectors from you. what's your paypal?

Pm sent

payment sent!

Injectors sold. Bump for everything else.

NB HVAC conversion parts pending.

Bump for offers on the dual gauge pod

Interested in the pod, is it specifically for a miata or more of a universal fit?

That's a good question. It came off a car that had an FM kit, but I don't know for sure if that means its miata specific. When I've held it up to my A piller it seems to match the contours fine.

Gotcha. One more question: what are the hole sizes for the pods? Im looking to move my gauges from my eyeball vents. Need to make sure they will fit

Another good question. They are for 2-1/16" gauges.

Third and final question: where do I send my payment? ;)