500+ hp Turbo kit
12-06-2008, 07:42 PM
#1
Junior Member
Thread Starter
Join Date: May 2006
Location: Ft. Worth Texas
Posts: 84
Total Cats: 0
500+ hp Turbo kit
Parts included:
T1 Race Development Tubular Stainless Manifold
Full Race Spec Garrett GT30r Turbo
24x12 Precision intercooler with Miata mounting plates
Full 3'' (Downpipe to Tailpipe) Exhaust
Braided Stainless Oil Feed, and Oil return (all red and blue AN fittings)
Braided Stainless Water Feed, and Water Return (all red and blue AN fittings)
(No Intercooler piping included)
$1750.00 + Shipping
My car made 500 WHP with this setup with still some room to play with. The turbo is still small enough where it made a lot of low end grunt as well. Here is a few pics that might help seal the deal.
Older dyno sheet
T1 Race Development Tubular Stainless Manifold
Full Race Spec Garrett GT30r Turbo
24x12 Precision intercooler with Miata mounting plates
Full 3'' (Downpipe to Tailpipe) Exhaust
Braided Stainless Oil Feed, and Oil return (all red and blue AN fittings)
Braided Stainless Water Feed, and Water Return (all red and blue AN fittings)
(No Intercooler piping included)
$1750.00 + Shipping
My car made 500 WHP with this setup with still some room to play with. The turbo is still small enough where it made a lot of low end grunt as well. Here is a few pics that might help seal the deal.
Older dyno sheet
Reply
0
0
12-06-2008, 09:27 PM
#7
Junior Member
Thread Starter
Join Date: May 2006
Location: Ft. Worth Texas
Posts: 84
Total Cats: 0
Forgot to add that the exhaust flange on the turbo is v-band and 3 in, and so is the rest of the exhaust. The inlet is a 4 in with a compressor surge housing. Its a .60 AR.
The muffler is an Apexi N1.
The muffler is an Apexi N1.
Reply
0
0
12-06-2008, 09:57 PM
#9
Junior Member
Thread Starter
Join Date: May 2006
Location: Ft. Worth Texas
Posts: 84
Total Cats: 0
The Manifold was built around the power steering pump and the ac compressor. You would just have to clock the turbo differently than I did, and route the piping around it! 
Last edited by 1BadMX5; 12-07-2008 at 02:32 AM.
Reply
0
0
