Koni coilovers & NB sport suspension parts(w/o Bilsteins) -$300 shipped obo
 

Just swapped my shocks for Bilsteins and threw this setup together with the left overs.

https://www.miataturbo.net/attachmen...ine=1370127877

https://www.miataturbo.net/attachmen...ine=1370127877

https://www.miataturbo.net/attachmen...ine=1370127877

The complete FOUR (only 2 pictured) coilovers consist of the following:

-NA Koni adjustable Yellows - unknown mileage
-Koni threaded sleeves
-Ebay 2.5" springs - unknown rates, roughly #375
-Ebay spring isolators under top hat
-NB bump stops
-NB top hats
-FCM hardware and cut down bushings

NO adjustment tools are included, I just used two plumbers pliers, as pictured. The adjustment tool pictured IS included.

Please note: although the top hats are tight, the adjustable perches are NOT, and are just snugged up against the spring so it doesn't rattle around during shipping. You will have to adjust and tighten the perches once purchased.

Please note again: in case you're wondering, I was at the pictured height with about 1-2 inches of threads left front and back with these collars, so they can go plenty lower or plenty higher.

https://www.miataturbo.net/attachmen...ine=1370127877

I also have a box of left over parts from the NB Bilstein setup. 4 springs, 4 lower spring rubber isolator, 4 upper rubber spring isolators, 4 shock boots, 4 aluminum spring mounts, and 4 lower washers. I have NOTHING else left from the stock NB sport coilover setup. All the rubber pieces are a little dirty, but no tears in any of them.

I've gotta put a price, so I'll say $50 shipped. Reply here or PM me if you want just a few pieces out of this box and we'll discuss prices.

https://www.miataturbo.net/attachmen...ine=1370127877

How was the ride with this set-up? Too stiff for the street?

Not harsh at all. I haven't experienced these springs with the shocks, but they're a similar combo to what I had, which was very DDable.

The Konis don't have a lot of high speed dampening, so they can be a bit bouncy over wavy bumps, but they soak up jolts like pot holes and speed bumps very nicely.

How much to have them delivered to France, postal code 27220 ?

Thanks!

if you want to separate, i'll commit to the collars and sleeves right now. springs too if you want.

i'm sure you'd be able to sell the konis themselves easily after that. i already have konis though and i can't front the $$ to get the whole package right now. the konis will be $250 themselves i'm sure.

do you think that the springs are 375# front and rear? or is that just the front number?

Will you take 200 shipped

Thread is closed for a reason, these are sold.