MS1 for 90-93
#1
Cpt. Slow
Thread Starter
iTrader: (25)
Join Date: Oct 2005
Location: Oregon City, OR
Posts: 14,175
Total Cats: 1,129
MS1 for 90-93
I'm upgrading to an MS2, and no longer need this one.
It was built by Wayne_Curr on the forums back in...2010? +/- a year.
It's running on the latest hi-res code, and works with VTPS and launch control (that's the single red wire running outside the harness), and has JP's spark output mod, so you don't have to run inverted spark, and I don't think you have to unplug the ignitor while loading firmware anymore. Don't quote me on that though, it's been a while.
I'll rewrap everything once it comes off the car to hide the LC wire though. MS case has been well protected over the years, but the patch harness has some overspray on it.
The patch harness was made by Braineack, and is bolted to a small piece of sheet metal, so you can bolt it to the floor like I did. Not 100% it'll all fit under the kick panel like that, but the little piece of sheet metal is removable.
Looking for $350 shipped, or a local can have it installed* by me for $400.
*does not include highly recommended wideband install.
Includes the MS and patch harness, no serial cable for now. Available for ~$10 at your local electronics store.
The only two wires you'll need to run is the launch control to ground (or a switch, then ground, if you want to turn it on/off), and the purple wire shown to your fuel pump relay.
It was built by Wayne_Curr on the forums back in...2010? +/- a year.
It's running on the latest hi-res code, and works with VTPS and launch control (that's the single red wire running outside the harness), and has JP's spark output mod, so you don't have to run inverted spark, and I don't think you have to unplug the ignitor while loading firmware anymore. Don't quote me on that though, it's been a while.
I'll rewrap everything once it comes off the car to hide the LC wire though. MS case has been well protected over the years, but the patch harness has some overspray on it.
The patch harness was made by Braineack, and is bolted to a small piece of sheet metal, so you can bolt it to the floor like I did. Not 100% it'll all fit under the kick panel like that, but the little piece of sheet metal is removable.
Looking for $350 shipped, or a local can have it installed* by me for $400.
*does not include highly recommended wideband install.
Includes the MS and patch harness, no serial cable for now. Available for ~$10 at your local electronics store.
The only two wires you'll need to run is the launch control to ground (or a switch, then ground, if you want to turn it on/off), and the purple wire shown to your fuel pump relay.
#4
So this is basically plug and play with your supplied harness other than the fuel relay? Im not worried about the launch control at this point.
Thread
Thread Starter
Forum
Replies
Last Post
iluvtruenos
Miata parts for sale/trade
2
06-22-2007 08:23 AM