FS: 90-05 Flyin' Miata 10.3lb lightweight flywheel
08-10-2013, 03:25 AM
#1
Junior Member
Thread Starter
iTrader: (2)
Join Date: Jun 2012
Location: Sherwood, AR
Posts: 105
Total Cats: 0
FS: 90-05 Flyin' Miata 10.3lb lightweight flywheel
FM 10.3lb one piece all steel steel lightweight flywheel. Used for the 2012 autocross season, 8 events, so definitely less than 1000 miles on it.
These retail for $299+ shipping, I will part with this one for $200 shipped/insured with UPS ground to anywhere in the US.
Fits 90-93 1.6 and 94-05 1.8 miata engines, including 04-05 msm. Bearing not included.
These retail for $299+ shipping, I will part with this one for $200 shipped/insured with UPS ground to anywhere in the US.
Fits 90-93 1.6 and 94-05 1.8 miata engines, including 04-05 msm. Bearing not included.
Last edited by Red91; 08-27-2013 at 04:34 PM.
0
08-27-2013, 01:38 PM
#4
Junior Member
Join Date: Jan 2013
Location: Cincinnati
Posts: 62
Total Cats: 0
Would this need resurfacing before install?
0
08-27-2013, 04:31 PM
#5
Junior Member
Thread Starter
iTrader: (2)
Join Date: Jun 2012
Location: Sherwood, AR
Posts: 105
Total Cats: 0
You won't need to resurface, but definitely allow 250-500 miles of being easy on it to allow it to break in with your clutch properly, especially if you use a brand new clutch. Also there is a spot where surface rust started to form since I pulled it off the engine last month (coolant splashed on it), you can see it in the pic on the lower left. I guess I could have cleaned it and removed the bearing BEFORE I took the pic.. Anyways it's nothing that your clutch won't clean right off the pressure plate, the surface itself is smooth.
0
Thread
Thread Starter
Forum
Replies
Last Post
Frank_and_Beans
Supercharger Discussion
13
09-12-2016 08:17 PM
