Miata Turbo Forum - Boost cars, acquire cats. - RX7 TII Tranny and Adapter Plate.

Looking to sell. All it needs is the outside edges trimmed to the template
lines. Other than that, its pretty much all ready to put in (with a few other things, clutch slave cylinder and starter ) You need an rx7 TII driveshaft if you add an rx7 TII rear. Otherwise, I believe you would have to measure and have a custom driveshaft made up from driveshaftshop.com I think I was quoted less than 400 for it. (or modify an existing).

I was using this when I was building a 1.8 block, now I have no car so Im looking to get money so I can get the car up and running again.

The stage 3 miata 6-puck clutch disk w/rx7 spline will also be included. You need a Pressure Plate (1.8) and a Flywheel (1.8)

This is what you need for 300+ HP!

Im looking to get $750, I would prefer not to ship. Usually a pretty costly and time consuming procedure, but this is a big head start. The most painful part is taken care of.

PM or email me.