SADfab 3D printed VTPS brackets for 1.6
 

3D printed variable TPS conversion brackets for 1.6 miatas now available! This bracket allows you to mount a kia vtps(kia pt no. 0K24718911) to a 1.6l throttle body for use with aftermarket ECUs. The kia TPS uses the same connector as the stock 1.6 tps "switch" so there is no modification to the harness*. The bracket with included stainless hardware is $20 shipped. Contact us by email at info@sadfab.com if you would like a bracket.

*plug and play units may require 2 wires to be swapped in the harness.

Thingiverse link for more info or if you would like to print one yourself.
https://www.thingiverse.com/thing:2425389


https://scontent-ort2-1.xx.fbcdn.net...51&oe=5A24E562

https://scontent-ort2-1.xx.fbcdn.net...1e&oe=5A2B1405

I had to take down the thingiverse link due to rampant pirating. Good lesson to never release a 3D printed file again.

Price reduced, please contact us at info@sadfab.com if you'd like one! please do not PM here.

Old thread, but hope these are still available.

Pretty sure SADFab is done for, and their page is just a zombie website at this point. I sent multiple emails and messages through their website and got no response, and that was over a year ago.

Well I emailed after a google search and I got a reply. Was told they pretty much sale on eBay with a link. just placed my order. https://www.ebay.com/itm/15552527657...mis&media=COPY

Well, I guess that's a shoe in mouth moment. Glad you got it sorted, and I guess it's good that their still in business. I wish they were a bit more clear about what was actually available for sale though...

well I did try the site without much luck. As I mentioned earlier, I googled and found an email address. Figured I’d give it a try and it worked. So your assumption wasn’t exactly wrong.