gdnimr0d

iTrader: (16)

Here is a complete list of the parts i have .i have run out of space at my shop and need them all gone ----first local buyer with $400 takes it all ….if not text me for individual prices and parts
99-05
-throttle body with tps (no iac)
-01-05 glass fog light
-01-05 glass inner pieces from oem headlights
-complete set of front and rear ABS sensors
- a/c controller
-injector harness
-cold air intake piping with mass airflow sensor
-01-05 intake manifold complete
-01-05 injectors with fuel rail and harness
-gauge cluster
-gauge cluster hood cover
-ash tray
-crank pulley timing discs
-fuel dampener assembly on passenger shock tower (with oem quick release lines)
-timing belt covers upper and middle
-x3 a/c ball vents
-rear main seal housing for 1.8 engine
-x2 non cruise headlight/windshield washer control switch
-complete powersteering rack with pump and resevoir
-5 speed shift **** oem
-aluminum cowl radiator cover duct aftermarket
-hood latch
-99-00 x3 intake and exhaust cam gears with bolts -
-plastic steering wheel surround cover
-high pressure oem oil pump
-x2 sets of radiator brackets with hood prop plastic mount
-cylinder head rear coolant sensor
and flange with heater nipple
-oem intake air temp sensor
-radio din pocket oem

90-05
-shifter boot
-transmission to engine plate

94-97
-x4. 1.8l mass air flow sensors
-brand new rear brake rotors in box
-brand new mazda oem rear brake pads
-front 1.8l brake calipers
-fuel pump and level assemble

90-97
-cigarette socket and lighter
-driver side turn signal
-driver and passenger black seatbelts with locks
-gas/trunk cable and levers
-p/s tensioner bracket with hardware
-hood hinges
-x2 battery hold down brackets (no hardware)
-all three timing covers with rubbers-
-x2 p/s pump and 1 reservoir with soft lines
-windshield wiper arms
-hood latch
-L and R headlight motors
-x3 front bumper side markers with bulb sockets
-p/s pump bracket to engine
-trunk latch
-clutch master and slave cylinder
-rear view mirror with mount
-front lower control arms x2 left and 1 right
-front upper control arms x2 left and 1 right
-used oem complete good front shock assembly
-a/c controller
-x2 waterpump pulleys
-x2 5spd shift ***** oem
-left side (driver) manual window regulator
-x2 5speed gear shifters


90-93
-complete 1.6 head with valve cover
-Brand new mazda 1.6 bare cylinder (still in mazda box)-
-1.6 engine ecu-
-ignitor chip-
-x4 cam angle sensors-
-throttle body with tps (no iac, has bent throttle cable plate)
-injector harness
-brand new exedy oem replacement clutch complete in box
-92-93 long nose crank shaft pulled
-water pump v groove pulley
-intake snorkel tube oem


call or text me at 754 two four four 17fivefive
thanks

4ddiction

How much for a full set of upper and lower control arms? Front and rear

VRRMPSH

iTrader: (2)

Can you upload a pic of the aluminum radiator cowl? I'm interested in that.

Monk

iTrader: (3)

Sent you a PM.
Need some stuff

Monk

iTrader: (3)

Are you interested in selling this stuff?

x_25

He says to call or text at the end. I already have a box on the way. Just shoot him a text.

Monk

iTrader: (3)

Good call. I completely missed that sentence.

hox

can you post a picture of the radio din pocket. Is the the type that fits in the airbag defeat/cig lighter slot?

gdnimr0d

iTrader: (16)

hox yes it is if fits below the radio

EVERYONE PLEASE TEXT ME AT 754 244 1755

I have pictures and fast response times through my phone

gdnimr0d

iTrader: (16)

bump prices super cheap