Toyota COPs - $110 for 6
 

Got a box full of COPs. They work fine, I just have a fancy COP plate and I didn't see if these ones would fit it before I bought them. My mistake means more for you!

6 coils, they all mount in the same (wrong for me) way, so if you're looking to DIY up a plate then this is a full set plus two spares!

$110 + PayPal fees shipped in the lower 48. Got a set of 90919-02239 coils? Let's trade!


https://cimg4.ibsrv.net/gimg/www.mia...2b428c0033.jpg

When I was hunting cop's down, I couldn't find ones with the straight bolt pattern that were the right length. They were all to long. Can you double check the length on these?

They stuck out of my head a bit, but with the thickness of the plate I was using they seemed ok, bolt spacing was just off for me. I'll measure them when I get home tonight.

The overall length is the same, but the mounting collar is higher. The ones on the left are the ones I'm selling, the ones on the right are the other COPs that work with my plate.

https://cimg5.ibsrv.net/gimg/www.mia...728cce9d8e.jpg

Those look like the V6 COPs that I have and I have a 1" thick mounting 'plate'. Anything less and they stand out waaay to far.

Yeah, not sure what they're from. Bought them before I looked at my plate. Saying "waaaay" too far is a bit generous, as the sealing surface is less than 1/2" higher than the other ones. The width basically fills the entire spark plug well with Toyota COPs anyway, so just putting a round spacer on the bolt would keep them in place just fine and keep stuff out of the plug well.

Yup, you are absolutely right. I wasn't trying to thread crap, if that's the way it came across, je m'excuse. Plus, if the mounting plate had holes 'just' big enough for the cops to pass through, there would be no need for a spacer - weight reduction, lol.