WTS Engine w/FM II Hydra Complete.
So WTS Compete Motor, Turbo System, Tranny, Rear End w/ Torsen II LSD.
99 Head, Ported Polished 03 Block, Bored 30 over, Honed, Balanced Internally Mazdaspeed Thrust Bearings Boundry Engineering Billet Oil pump gears, Wisco 9:1 FM pistons, Eagle H-rods, Hydra EMS Stand Alone , GT-2860 Turbo RC 550cc Injectors, ACT Clutch, HKS Bov, HKS Internal Waste-gate, PWR Radiator, Precision Intercooler, Racing Beat Full Cat Back exhaust, AEM Wideband, AEM Tru-Boost. Have Pictures of Engine Being Built and Video as well. http://s1126.photobucket.com/albums/l618/jaredpmoser/ Also have Video of engine running. $4,000 obo. |
Willing to seperate?
|
would rather sell together it depends. What did you have in mind.
|
damn, that sounds like a pretty damn good deal! GLWS!
|
I'll interested at Precision intercooler if you decide to part out. Which model is it?
|
Please check your inbox. Thanks.
|
So basically for less than what a new FM II Hydra costs, you get the kit PLUS built engine, trans, radiator and a torsen...
/head explodes |
Yes. Just trying to pay to finish my v8 swap. Bought everything pulling motor next week.
Wiring harness Wideband 02 for hydra has AC. Everything u can have rear axels if needed will not need them. Just want it all gone. I am really surprised how much and fast I am getting offers just put this up. Can ship anywhere as well the shop pulling ships JDM motors / trans and front clips all over US. |
If I didn't already have a built setup, I would buy this.
Damn, GLWS, amazing set-up |
If you was local I would have been infront of ur door paying you.
|
Interested in the Torsen with axles and drive shaft if you decide to part out.
|
Originally Posted by Justslow
(Post 695669)
If you was local I would have been infront of ur door paying you.
|
5 Attachment(s)
|
Awesome deal for someone. GLWS.
|
PM me a hydra price if you split
|
PM me a price on the 2860 if you split. Thanks.
|
parting out the setup yet??
|
What would shipping be on all of this??? Sounds like it would be a pain in the ass...I am really considering this and throwing it into a shell.
|
Have you looked into shipping? I'm at 59057 zip code. How many miles were on the motor built (or hours if you just ran it and didn't drive) and did you properly break it in yet? Who did the machine work? What about the port work? And what sort of valve springs/valves are in there as well? Also, its got a MBSP right? Any crank scraper installed?
Pretty interested. I was going to build my own motor, but this will be close to the same damn price. |
Wow what a deal.
|
All times are GMT -4. The time now is 10:05 PM. |
© 2024 MH Sub I, LLC dba Internet Brands