Enhanced Megasquirt - now with more features!
#24
Elite Member
Thread Starter
iTrader: (10)
Join Date: Jun 2006
Location: Athens, Greece
Posts: 5,976
Total Cats: 355
Oil temperature and pressure configuration settings:
Sensors used: Temperature, pressure, both
Oil temp sensor type: Same as coolant, same as IAT, linear
The CEL is used again to warn of possible problems.
Sensors used: Temperature, pressure, both
Oil temp sensor type: Same as coolant, same as IAT, linear
The CEL is used again to warn of possible problems.
#25
How do you get 5v out of the oil pressure and oil temp sensors...?
#28
O.K. this is where my electronic knowledge craps out...
#29
Elite Member
Thread Starter
iTrader: (10)
Join Date: Jun 2006
Location: Athens, Greece
Posts: 5,976
Total Cats: 355
Went for a test drive on the second prototype of the "Lite" line. Knock sensing is AWESOME. Look below, each time I was hearing knock, I was automatically backing off the throttle. Datalog confirms there was severe knock, and the CEL was lighting up as expected:
Settings for this:
I need to increase the threshold between 4000rpm and 6000rpm though.
Settings for this:
I need to increase the threshold between 4000rpm and 6000rpm though.
#39
When will these be available? looking to buy a MS in the next week, or at least place the order for one.
#40
It would be great to have Alternator constrained by TPS too. Ideally you'd want the alternator only working under light or no-load (engine) conditions.