OBDII Wideband module V2.1 Connection Issues
#1
Junior Member
Thread Starter
iTrader: (1)
Join Date: Oct 2013
Location: SoCal
Posts: 168
Total Cats: 4
OBDII Wideband module V2.1 Connection Issues
Hi all,
I have a 99-00 MS3 Basic with 1.40 firmware. I'm trying to connect my OBDII module and had no success with my AEM X series wideband. The module will not connect. I followed the directions from Trackspeed engineering website for the AEM wideband but still to no avail. Is there a different ini file for the module to run the AEM wideband? I also tried using both AEM options from the "CAN Wideband/EGT Module Settings". I've attached the photos of my settings and the ini file I'm running v104.
I've pinged @Reverant a few times via email and no luck.
http://www.mslabs.gr/can_module_104.zip
I have a 99-00 MS3 Basic with 1.40 firmware. I'm trying to connect my OBDII module and had no success with my AEM X series wideband. The module will not connect. I followed the directions from Trackspeed engineering website for the AEM wideband but still to no avail. Is there a different ini file for the module to run the AEM wideband? I also tried using both AEM options from the "CAN Wideband/EGT Module Settings". I've attached the photos of my settings and the ini file I'm running v104.
I've pinged @Reverant a few times via email and no luck.
http://www.mslabs.gr/can_module_104.zip
#3
Elite Member
iTrader: (37)
Join Date: Apr 2010
Location: Very NorCal
Posts: 10,441
Total Cats: 1,899
I received a response from Reverant via email. Once I find a solution I'll post it here.
I didn't realize there were version numbers printed right on the PCB mask, I might have to pop mine open and take a look.
Thread
Thread Starter
Forum
Replies
Last Post
thumpetto007
Miata parts for sale/trade
17
07-28-2017 06:19 PM
Efini~FC3S
Miata parts for sale/trade
7
11-18-2015 09:11 AM