MSPNP Flat Shift problem
#1
Junior Member
Thread Starter
iTrader: (4)
Join Date: Jan 2009
Location: Fife, Scotland
Posts: 317
Total Cats: 10
MSPNP Flat Shift problem
Hi guys,
I searched for a solution to this problem already and found this thread, but no resolution.
I wired in the launch control today (connected pins 12 and 13 together) as per the MSPNP documentation but it didn't work. I connected one wire of the clutch switch to ground, and the other wire to pin 12 on the MSPNP centre connector.
After I did this, launch control works as it should and only arms when the clutch is pressed down.
The problem is that flat shift is kicking in even though the clutch isn't pressed down. For example I can be accelerating in any gear and when it gets to around 5700rpm the flat shift intervenes and prevents it revving any higher.
Anybody got any bright ideas?
MSPNP 94-95
I searched for a solution to this problem already and found this thread, but no resolution.
I wired in the launch control today (connected pins 12 and 13 together) as per the MSPNP documentation but it didn't work. I connected one wire of the clutch switch to ground, and the other wire to pin 12 on the MSPNP centre connector.
After I did this, launch control works as it should and only arms when the clutch is pressed down.
The problem is that flat shift is kicking in even though the clutch isn't pressed down. For example I can be accelerating in any gear and when it gets to around 5700rpm the flat shift intervenes and prevents it revving any higher.
Anybody got any bright ideas?
MSPNP 94-95
Thread
Thread Starter
Forum
Replies
Last Post