mckabe

I can not get launch control to work with my clutch switch. i read in another post that my input has to be flex but under settings i do not have that option. What should my settings be and do i have to make any other connections im forgetting about. Sorry if this seems like a dumb question, but i am lost on this. Thank You for the help.

Matt Cramer

The latest MSPNPs simply call the launch pin Launch to reduce confusion.

mckabe

So where are my settings wrong? What should my input be for stock switch.

zero415

you have a 90-93 that means that you dont have a VTPS, so im betting your TPS is either always at 0 or a random negative number.


you need to change your tps calibration settings to it makes it look like your tps is above 0 then change your launch control to activate if tps is above 0.

mckabe

Tps is zero, what should my input NE?

mckabe

Can any one run me through this? Apparently I'm missing a step.

curly

iTrader: (25)

I had to manually enter some TPS values for our MSPNP gen 1 launch control, since we didn't have a VTPS. That's the best thing to do, is buy a VTPS. You could try my values, but I have no idea if they'll work for your gen 2.

For the "enable launch control when TPS above" value, I used 30.

I can't remember if I "calibrated" the TPS with their tool or not. If the above value doesn't work, try that first. I believe "closed throttle ADC count" worked, but for WOT, I had to manually enter a value of 30 or 40 I think. Whatever is higher than the closed throttle.

Which is all very funny, because our TPS is completely unplugged.

But launch control works amazingly at the flip of a switch.

Bmxicanjohn

iTrader: (2)

Did you ever figure this out? i'm looking to set mine up aswell.