Adding inputs
 

The stock guage cluster has the fuel, oil pressure and speedomiter

I have two 97 MSPNP's one has a bad map sensor the other is in the car. I have already had to remove and resolder the map sensor thats on the current working one

Is there a way I can canablize stuff off of it to i can put more inputs on the one that is currently in the car? Or is there other things on the current one that i can connect to?

I'm wanting to create a carPC set up and rip out the guage cluster. Install a small screen where the guages currently are, and just use tuner studio as its display.

Biggest problem i have right now is the speedomiter, i could put the oil pressure and fuel in the outermost pods on the stock guage setup, and replace the two large and the center circles with a single screen, but then have the issue with tracking mileage and stuff like that. I could put that guage in the glove compartment so it still records and if there is a way to get digital data on speed, then send that to MS somehow. using the speed guage in TS, it constantly sits at 28, i put in the gear ratios, but it does not seem to use that.

The car has cruse control, I cannot remember if that had any kind of sensors to determine speed for the cruse control system

I'd like to see this too so i can log gray and black-water levels.