Quick Question in regards to base timing.
12-08-2014, 08:37 PM
#1
Newb
Thread Starter
iTrader: (2)
Join Date: Sep 2014
Location: Pittsburgh, pa
Posts: 32
Total Cats: -1
Quick Question in regards to base timing.
I'm looking to get all my ducks in a row tonight since I'll be installing my ms2pnp tomorrow after work on my 91.
Here's my question
All the information I've seen in the guides and videos and what not for setting base timing as been based off the previous versions of ts or even mega tune. When using the up to date ts do I still change the "Use Table" settings to -10* once I set the "Fixed Timing" to 10*?
Before the noob bashing begins I tried searching but all I can find is the older versions and just want to make sure before I blow my car up
any info would be great thank you!!
Here's my question
All the information I've seen in the guides and videos and what not for setting base timing as been based off the previous versions of ts or even mega tune. When using the up to date ts do I still change the "Use Table" settings to -10* once I set the "Fixed Timing" to 10*?
Before the noob bashing begins I tried searching but all I can find is the older versions and just want to make sure before I blow my car up
any info would be great thank you!!
Reply
0
0
12-09-2014, 08:08 AM
#6
Boost Czar
iTrader: (62)
Join Date: May 2005
Location: Chantilly, VA
Posts: 79,493
Total Cats: 4,080
1. RTFM.
2. It's pretty damn EZPZ if you look at the screen: you have a picker for use table or fixed, then a field to input the exact timing you want to set it to.
setting to -10 tells the MS to set the timing to -10°.
This is MS2 not MS1.
Everyone that suggested -10 should be banned, sixshooter...
2. It's pretty damn EZPZ if you look at the screen: you have a picker for use table or fixed, then a field to input the exact timing you want to set it to.
setting to -10 tells the MS to set the timing to -10°.
This is MS2 not MS1.
Everyone that suggested -10 should be banned, sixshooter...
Reply
0
0
12-09-2014, 08:31 AM
#7
Newb
Thread Starter
iTrader: (2)
Join Date: Sep 2014
Location: Pittsburgh, pa
Posts: 32
Total Cats: -1
1. RTFM.
2. It's pretty damn EZPZ if you look at the screen: you have a picker for use table or fixed, then a field to input the exact timing you want to set it to.
setting to -10 tells the MS to set the timing to -10°.
This is MS2 not MS1.
Everyone that suggested -10 should be banned, sixshooter...
2. It's pretty damn EZPZ if you look at the screen: you have a picker for use table or fixed, then a field to input the exact timing you want to set it to.
setting to -10 tells the MS to set the timing to -10°.
This is MS2 not MS1.
Everyone that suggested -10 should be banned, sixshooter...
Reply
0
0
Thread
Thread Starter
Forum
Replies
Last Post
