firmware and basemaps mspnp1 help request
 

Hi,

I have searched, but I am uncertain of how to proceed.

I have a stock engine 96 miata. I installed the mspnp1 with the maf, and the car ran just fine. I am using tunerstudio lite at present. The NB gauge was red, but the car ran fine. I have not installed my wb yet.

Today I went to install the gm ait sensor. I did so following diyautotune instructions. As indicated, I updated the firmware to 029y4a, and uploaded the basemap mspnp_9697_basemap_012808 using tunerstudio.

I get a number of error messages related to unit mismatches, four of which seem to be related to idle settings.


I tried starting the car and it cranks, fires, goes into high idle and then dies in about 5 seconds.


I THINK the issue is that I am loading an older basemap designed for the older hr10_g firmware, but I am using the newer 029y4a firmware? Is this assumption correct?


If so, where can I find compatible firmware/ basemaps?


Thanks

Ok everyone calm down... I figured it out.

For furture reference:
Hr10 is the new firmware, 029y is older (although somewhere on the msextra pages it says that it is the newest).

I downloaded hr10 to the mspnp1 along with the basemap all found on the diyautotune pages. Reset basetiming on tunerstudio, and everything is fine.