Differences between AFM and IAT setup with MSPNP
05-13-2011, 04:34 PM
#1
Junior Member
Thread Starter
Join Date: Oct 2009
Posts: 89
Total Cats: 0
Differences between AFM and IAT setup with MSPNP
TunerStudio reports the VE fuel table is the only difference in the the two .msq files. Is this correct?
Are there any other settings that I need to change? I just went to the IAT and it was acting at tad odd at idle on the first start, but otherwise seemed okay. This car never runs quite right till it warms up. Working on that.
Does the MSPNP use the AFM data at all?
Jon
Are there any other settings that I need to change? I just went to the IAT and it was acting at tad odd at idle on the first start, but otherwise seemed okay. This car never runs quite right till it warms up. Working on that.
Does the MSPNP use the AFM data at all?
Jon
Reply
0
0
05-16-2011, 12:34 PM
#4
Boost Czar
iTrader: (62)
Join Date: May 2005
Location: Chantilly, VA
Posts: 79,490
Total Cats: 4,079
the only difference is the internal configuration for the air temp sensors. One being the OEM one inside the AFM, the other being that of the GM sensor.
If you use the wrong firmware/project your reported air temperature readings will be off.
If you use the wrong firmware/project your reported air temperature readings will be off.
Reply
0
0
Thread
Thread Starter
Forum
Replies
Last Post
