MSPNP 2 Launch control/rev limit
#1
MSPNP 2 Launch control/rev limit
Hello all I finally got my MS running!
the firmware is pre 3.3.0 beta 16 (came on the unit)
I have set my rev limit to spark cut and i have enabled launch control with spark cut but the launch control doesnt seem to work.
per MS i have it set to use the default clutch switch and the board had the jumper pin on pin group 4 per the manual.
Do i need to jumper any wires on the clutch switch for a 93 1.6?
the firmware is pre 3.3.0 beta 16 (came on the unit)
I have set my rev limit to spark cut and i have enabled launch control with spark cut but the launch control doesnt seem to work.
per MS i have it set to use the default clutch switch and the board had the jumper pin on pin group 4 per the manual.
Do i need to jumper any wires on the clutch switch for a 93 1.6?
#6
I forgot to mention and it totally slipped my mind but my 93 is equipped with cruise control. would this cause issues when i try to use launch control? If so is there anything I need to wire up to bypass it?
edit:
per this link they are also having issues with launch control.
https://www.miataturbo.net/mspnp-55/...pressed-65437/
could this be my issue as well?
edit:
per this link they are also having issues with launch control.
https://www.miataturbo.net/mspnp-55/...pressed-65437/
could this be my issue as well?
Last edited by zero415; 03-13-2014 at 09:06 PM.
#8
its just odd that i have everything set up per the manual to use the stock clutch switch and with launch control enabled it never activates when the clutch pedal is pressed to the floor.
like I said, I dont know if my 1.6 having cruise control with two switches on the clutch pedal would cause an issue or not. ill make a log sometime this weekend and review/post it.
like I said, I dont know if my 1.6 having cruise control with two switches on the clutch pedal would cause an issue or not. ill make a log sometime this weekend and review/post it.
#9
Im still having issues with launch control on the MSPNP2.
here is a screen of my settings out of the box. All i did was enable LC. I have also included a log in which the clutch pedal is pressed in and launch control doesnt engage. the log is 20mb so i used dropbox to link it.
https://www.dropbox.com/s/dpjcr1507g...ontrol_log.msl
here is a screen of my settings out of the box. All i did was enable LC. I have also included a log in which the clutch pedal is pressed in and launch control doesnt engage. the log is 20mb so i used dropbox to link it.
https://www.dropbox.com/s/dpjcr1507g...ontrol_log.msl
Thread
Thread Starter
Forum
Replies
Last Post