Rev limiter not working!
1 Attachment(s)
While tuning over the weekend I noticed my rev limiter is not working. Overboost protection works. Launch control works. Soft cut & hard cut rev limiters do not work. Soft cut is supposed to be at 7200. Hard cut should be at 7300. I can rev easily past 7500 (in megatune) before I let off the throttle.
Has anyone experienced this/know how to fix it? I've already tried reflashing the firmware to no avail. Msq & Msl attached in rar file. Someone help! |
just curious, have you tried setting it to something low like 2k just to test?
|
Ok, I did this ^. Limiter works now. Very strange.
|
sometimes MT is finicky like that.
|
Maybe it is slow to respond? Set it at 6000 or 6500 and see how it does?
I think I noticed this too... |
Mine is set to 7100rpm (HARD) with these settings:
Base number: 5 Fuel only Sparks base number: 3 (Soft is set to 7300, so I don't use that) Bouncing the rev limiter will show it hover around 7250-ish. |
What code are you guys using? I have hr_10g.
Like spookyfish, I've noticed that the rev limiter ends up being 2-300rpm higher than the hard cut... so I just set it a few hundred rpm low. Right now I have it set to 7400, and it peaks at about 7650. I think I'll reduce the hard cut to 7350.... |
Originally Posted by JustinHoMi
(Post 441504)
What code are you guys using? I have hr_10g.
Like spookyfish, I've noticed that the rev limiter ends up being 2-300rpm higher than the hard cut... so I just set it a few hundred rpm low. Right now I have it set to 7400, and it peaks at about 7650. I think I'll reduce the hard cut to 7350.... |
Hah, you're quick to make assumptions. What makes you think I'm looking at the tach?
|
Originally Posted by JustinHoMi
(Post 441725)
Hah, you're quick to make assumptions. What makes you think I'm looking at the tach?
|
All times are GMT -4. The time now is 09:16 AM. |
© 2024 MH Sub I, LLC dba Internet Brands