BEGI Shanghai - lean under WOT
Problem is that AFR is ~13.2 under WOT and fuel pressure gauge shows only 70PSI(after closing needle valve shut, before only 60 and dropping) first and then drops ~65PSI which is way less than described in manual. Under part throttle it shows 11.6 to 12.5
Idle and vacuum pressures are as described in BEGI manual and when line is closed shut it shows 85+PSI on idle Question is what to do next? Replace injectors to toyota 315cc(as i have them) and tune or Replace fuel pump ( I could get 190LPH or 255LPH for good price) |
Both.
|
you may not be able to idle injectors that large. people typically move to 1.8 injectors to ensure adequate fueling while in boost. yes, a stronger fuel pump is a good idea too.
|
Thank you for replies. Unfortunately it is almost impossible to get 1.8 injectors here (unless you get them from US) so i just need to give a shot on 315cc first.
|
Originally Posted by budget racer
(Post 554994)
you may not be able to idle injectors that large. people typically move to 1.8 injectors to ensure adequate fueling while in boost. yes, a stronger fuel pump is a good idea too.
|
I'll give them a try then.
When i searched web for injector codes i found following info on toyota 315cc ones: http://www.witchhunter.com/flowdatapix/d2325074080.jpg and according to same website supra ones are actually stronger (took the part code from Miata Turbo Wiki page) http://www.witchhunter.com/flowdatapix/d2325070080.jpg |
https://www.miataturbo.net/useful-saved-posts-8/diy-faq-all-your-answers-one-big-post-10821/
this thread has good info on everything and answers to your injector question! |
tnx mekaw, i have allready readed that post as well i'm regualr visitor to Miata Turbo Wiki page.
|
Success after installing toyota 315cc injectors.
Once injectors were in place, car started right away (AFR ~11 on idle). Tuned a bit using idle mixture screw on AFM and got idle AFR back to ~14.7 Now under boost AFR is ~10.8-11.1 ( need more tune on airfield as on road it's bit difficult). Also capped BKR7E-11 plugs to 0.8mm instead 1.1mm 190LPH pump is on order. |
I think most people recommend bkr7e and gapped to .030
|
Originally Posted by redeagle
(Post 557266)
Success after installing toyota 315cc injectors.
Once injectors were in place, car started right away (AFR ~11 on idle). Tuned a bit using idle mixture screw on AFM and got idle AFR back to ~14.7 Now under boost AFR is ~10.8-11.1 ( need more tune on airfield as on road it's bit difficult). Also capped BKR7E-11 plugs to 0.8mm instead 1.1mm 190LPH pump is on order. didn't your car run filthy rich just cruising? before you hit the boost? I remember when i put on supra injectors well 305cc without management and did what you did, it ran fine underboost but for normal cruising it was running relatively around 11ish for afr. |
That's the interesting part, on cruise AFR is like it was before ~14.7 99% of the time, only sometimes i see ~12.2 for a short time.
|
All times are GMT -4. The time now is 10:19 AM. |
© 2024 MH Sub I, LLC dba Internet Brands