Greddy kit oil drain flange clarrification question.
im getting ready to tap my oil pan for the oil return and im planning on doing steel braided lines for it.
i know the sizes r specified in braineacks faq, but i had a question on the flange i should buy. http://cgi.ebay.com/ebaymotors/Funct...spagenameZWDVW this is the one i've been people pointing at to get, but it doesn't mention the td04h-15g turbo just the 16g. is the 15g and 16g the same ? will this flange work for my application. thanks Scott |
I bought one of those from Function7 - I believe that the TD05 flange fits the TD04, but I can measure mine tomorrow, if you can wait.
Make sure you tap the pan with the same size NPT fitting that the flange uses - I tapped my pan for a 1/2" NPT fitting, and had to drill/tap the Function7 fitting to use a 1/2" hose as a result. I've got pictures of it here, if it helps: click In the end, I used a the fitting from the DSM car: made it simpler to route it towards the pan with my setup. Cheers! Jeff |
ATP has the correct flange with the holes slotted slightly to fit quite a few different turbos. Its machined 1/2" NPT.
|
ok, so i think i figured it out.
im gunna order that flange, which has a 3/8" female NPT port. then i plan on buying 2 x 3/8" npt male -> -10AN male http://store.summitracing.com/partde...5&autoview=sku one of these, to screw onto the turbo. http://store.summitracing.com/partde...5&autoview=sku and one of these http://store.summitracing.com/partde...5&autoview=sku to screw onto the oil pan area where i will tap the oil pan for 3/8" npt. does this sound like a solid setup ? |
uh i didn't use a flange i just tapped and installed hte fitting in the pan, and used some jbweld to hold it in place.. the turbo is already threaded isn't it?
|
my turbo has the goofy 45 degree slip on fitting right now. so i was gunna get the flange.
as for the oil pan. the 3/8" male to -10 an male i was going to jbweld into the oil pan tap location. |
Originally Posted by shinobix
(Post 131508)
my turbo has the goofy 45 degree slip on fitting right now. so i was gunna get the flange.
as for the oil pan. the 3/8" male to -10 an male i was going to jbweld into the oil pan tap location. |
All times are GMT -4. The time now is 08:45 AM. |
© 2024 MH Sub I, LLC dba Internet Brands