Adjusting Boost w/ Actuator Rod & MBC
#1
Adjusting Boost w/ Actuator Rod & MBC
This might be a dumb question, but is there a preferred way to adjust boost using the actuator rod and a manual boost controller? In other words, should I adjust the rod for low boost, and turn up boost to desire range using the MBC? Or, adjust the rod for high boost, and turn down the MBC for my desired boost?
Right now, my Begi bent-arm 7 psi actuator rod is extended out quite a bit (to make it longer), and I've adjusted the MBC to get about 8 psi. But the spool is really slow, so I'm wondering if setting the boost differently will allow for quicker spool.
Right now, my Begi bent-arm 7 psi actuator rod is extended out quite a bit (to make it longer), and I've adjusted the MBC to get about 8 psi. But the spool is really slow, so I'm wondering if setting the boost differently will allow for quicker spool.
Thread
Thread Starter
Forum
Replies
Last Post
elesjuan
Build Threads
9
11-14-2018 12:18 PM
stoves
Suspension, Brakes, Drivetrain
5
04-21-2016 03:00 PM