Ignition advance & Fuel pressure with begi S1
What ignition advance (baseline) should I use with begi S1 kit. I have IC size#2, Begi AFPR and otherwise stock car. IŽll put 5psi boost. What kind of fuel pressures should I see with 5psi? IŽll get MSPN and more boost later this winter... Cheers!
|
Will depend on what OCTANE fuel you have available. I don't know what the conversions are, but if you have access to 93+, and you are IC'd, then you should be able to run 7* BTDC... perhaps as much as 8*, but listen closely for knock.
It's a 1.6, right... probably see about 70psi of fuel pressure for decent AFR's at 5psi boost. |
I have 98ron(similar to 93 US octane) fuel available. And my car is 1.6. IŽll try 8btdc timing. Thanks!
|
Whatch ebay, you can find deals sometimes on Bipes, and really good deals on a MSD box.
|
i would suggest using the MSD box...it would help a lot and its like $150 i think
|
I will get MSPN9093 later this winter, so I dont need MSD box. I just want to do quick testdrive and vehicle inspection with turbokit before I put my car for 4months wintersleep...
Coming up during winter: ACT clutch, MSPN, Custom 2,5" Cat+exhaust, '99diff with Kaaz LSD. And boost UP! |
Originally Posted by Begi
The first step is setting the zero point pressure. Start the Engine and let it idle.
Observe the fuel pressure. It should be 28/30 psi.
Originally Posted by Begi
With the engine idling, pull the signal line from the BEGi fuel pressure regulator .
Observe the fuel pressure again. It should rise to about 47/49 psi. If different, loosen the jam nut and adjust the center screw until the pressure is 47/49 psi. Clockwise is more pressure. Snug up the jam nut. Plug the signal line back unto the FPR. The fuel pressure should return to the 28/30 psi figure.
Originally Posted by Begi
The second step is setting the fuel pressure at 8 psi boost. An approximate setting can be made with
the engine idling and giving the fuel pressure regulator an 8 psi signal from another source. However, it is more accurate to set the fuel pressure with the engine running under load. Drive the car and while adding boost increments with the throttle, watch the gauges to match 8 psi boost with 100 psi of fuel pressure. |
All times are GMT -4. The time now is 06:52 PM. |
© 2024 MH Sub I, LLC dba Internet Brands