Intake piping to swap out the Greddy pipe and the airbox.
 

I was looking around the CXRacing site trying to find something that works, but figured I'd ask for some suggestions from folks that have already done this. Not sure if I should have posted this in the DIY forum or here.

I'm going to an MS and will remove the AFM, so at that point I'd probably want to throw in a new intake pipe and rearrange things a bit to fit better. I've got the Stripes pipes and IC setup on it and will probably keep that.

Any ideas?

Check out this site for bends:
Tube Bending & Fabrication - Columbia River Mandrel Bending

Now I need to go get a tape measure and actually measure stuff.

You probably know about Intercooler Pipe Fabrication - Silicone Intake Systems Auto Parts but I'll mention it anyway.

Here's a shot of my bay with my old setup, but it'll show you what I intend to do with the Greddy I'm now running.

https://www.miataturbo.net/attachmen...y-cimg8292-jpg

Here's what it looks like now (random photo, not the greatest). My comp outlet pretty much heads straight down and out of the way of the inlet, so a crossover intake pipe as in the photo above will work.

https://www.miataturbo.net/attachmen...1&d=1374637760

Most people just buy an "intercooler kit" from ebay that comes with bunch of pipe, bunch of bends and clamps and make that work.