Greddy Manifold Studs?
#1
Greddy Manifold Studs?
Has anybody replaced the bolts with studs?
If so, can you please share with me the size you used (length)...my turbo is with BEGI so I am unable to size it up...I want to have the car ready to go when I get the turbo back
I plan on ordering from McMasters in SS unless you guys have a better plan
If so, can you please share with me the size you used (length)...my turbo is with BEGI so I am unable to size it up...I want to have the car ready to go when I get the turbo back
I plan on ordering from McMasters in SS unless you guys have a better plan
#4
I installed studs, WORST ******* IDEA EVER! They ALWAYS came loose, after say 100 miles or so, the turbo was loose. I installed nord lock washers from FM, still no luck. I installed helicoils and used that ultra high temp loc-tite ( which just burned off like the regular stuff) and they STILL came loose.
Swapped in some bolts with the nord lock washers, DONE. Now I have to fight to get the turbo off. I don't know why I didn't swap them out earlier, seems so freaking obvious now. On a side note I read around here SS is a bad idea because if they break they are next to impossible to drill out.
Swapped in some bolts with the nord lock washers, DONE. Now I have to fight to get the turbo off. I don't know why I didn't swap them out earlier, seems so freaking obvious now. On a side note I read around here SS is a bad idea because if they break they are next to impossible to drill out.
Thread
Thread Starter
Forum
Replies
Last Post