Silicone t-piece for BOV?
I have the BEGi-S turbo to throttle body tubing on my car. I want to add a BOV temporarily until I get the intercooler installation going. I would like to do this without screwing up the BEGi tubes so I can sell them later if need be.
So they are two 2" tubes with a coupler right in front of the valve cover. I am thinking if I use something like this silicone t-piece I'll be able to spread the tubes apart a bit at the coupler and fit a BOV in there. http://www.forgemotorsport.com/conte...FMTP-51_Black-[New%20Code] Problem is, I have looked at a few of these and for whatever reason no one indicates what the diameter of the tee line is, the small one. It looks to be a lot smaller than 51mm (about 2") but I cannot tell. Anyone used one of these to attach a BOV? Once I find this out I can go shopping for BOVs. Minor leakage at idle or whatever is OK since I am using MAP (MS). A few here seem to be happy with the Ebay Chinese knockoff valves, maybe something like this... http://cgi.ebay.com/ebaymotors/25MM-...spagenameZWDVW |
Here is what the tube looks like. The coupler I want to replace with the tee is right in front of the valve cover. From BEGi's page
http://www.bellengineering.net/Image...8_osN2Kj68.jpg |
OK kept looking and I am guessing from some other sites with the same looking t-fitting that the 'spout' is 25mm (about 1 inch). Seem correct? If so then I just need to get a BOV with a 1" inlet connection.
|
i have an ebay-type bov with a 2" "silicone t-piece" if you want one ;)
|
PM sent
|
99% of those T's are 1", specifically for mounting a Bosch OEM BOV.
Check it: https://www.miataturbo.net/forum/att...1&d=1163224580 |
All of our Ts have 25mm (1 inch) spouts.
|
Thanks for the info guys.
The OEM Bosch could work too. I am considering that one. I am not looking for a loud BOV, just one that works, is quiet, reliable, and can hold 12-15 psi. |
All times are GMT -4. The time now is 04:41 PM. |
© 2024 MH Sub I, LLC dba Internet Brands