Simple question about BEGi-S4 installation
Question is pretty basic. I'm mostly done with the disassembly part of the turbo installation with just a little bit to go, but I can't envision the coolant reroute very well and I could use a tip from anyone familiar with the process at this point.
Regarding this quote from page 6 of the installation guide: http://www.bellengineering.net/templ...ns_Series4.pdf The test says to pull off the cast aluminum neck. Do I pull it off from the rubber part, or pull it off from where it is anchored on the engine? Does it go back there later? Removing the Water By-pass: The water by-pass tube (located beneath the exhaust manifold, and anchored to one of the manifold/head studs) must be removed. Remove the power steering pump and it’s mount. Pull off the cast aluminum ‘neck’ that originally held onto the lower radiator hose. Refer to picture # 10 . The PWS pump will re-install later with a new water by-pass tube. |
Youre removing it from the engine. And using the one supplied by begi
its bolted to the water pump with 2 bolts |
Great, thanks! I was done at that point today and wasn't sure. :beer:
Measure twice and cut once and all that. :) |
All times are GMT -4. The time now is 04:56 PM. |
© 2024 MH Sub I, LLC dba Internet Brands