Temp sender location
#1
Junior Member
Thread Starter
Join Date: May 2008
Location: Grants Pass, OR.
Posts: 488
Total Cats: 17
Temp sender location
I just installed a FM11/Hydra kit on a 99 dedicated track car. I want to install a coolant temp gauge. Have a inline adaptor that goes in the upper hose. Was wondering if decreasing the inside dia. well pose any issues. As I understand it the ECT sensor on the back of the motor also controls the fans on the later cars so removing that is not an option. Where are most installing the sender on the later cars? Thanks John
Thread
Thread Starter
Forum
Replies
Last Post
JesseTheNoob
DIY Turbo Discussion
15
09-30-2015 02:44 PM