View Full Version : DIY Turbo Discussion
- GT3076R Boost Creep?
- dont flame. i want 2 lern
- 5V source under hood of 99?
- Q's - Check valves and miscellaneous bits
- new internal wg actuator installed
- DIY '96 Turbo needs finished- vacuum diagram for the 94-97
- coolant hose size?
- 1.8l turbo ?'s
- Anyone running low boost
- Turbo Water Lines Question
- Recommendations on EGT Gauge?
- Swapping just rods for 300hp
- DIY intake manifold parts source
- q's on 14b build
- New Fabricated Exhaust (RSR Inspired/Turndown/56K WATCHOUT)
- Honda injectors?
- Ported shroud/anti-surge housing
- Exhaust manifold thoughts
- DP for an HKS T25 Manifold
- Issues - Help?
- 97 1.8 Exhaust Header Flange
- Turbo Exhaust, Final questions!
- Single piece downpipe
- Anyone have the size of a T28
- What intercooler piping kit did you use?
- Need quick Help - identify this AN Fitting Size
- quick begi-s question
- Banjo Bolts
- WB sensor installation angle
- DIY pipe bead tool
- 400rwhp Stock Motor.
- After years of lurking, "Super 60" Build thread
- FM turbb manifold modification (studs)
- Turbo Miata Build Plan
- StripPed exhaust stud
- Tell me more about this turbo
- External wastegate - Pros and Cons
- Spring Fix For Tial BOV
- What goes here?
- Just orderd my EBC from DIY.-Now tuning-needs help
- Mandrel bent IC piping question
- BEGi is going to offer DIY kits
- capacity stock injector 2001 model
- ITBS + plenum + turbo = worthwhile gain?
- Turbo in an NC?
- Turbo Information
- Bolt size and thread pitch of coolant plug?
- FM DOD could be useful for someone
- Which ebay Intercooler would you buy?
- gt 2554r - 471171-3... Anyone using?
- How much power/spool with..
- Finally the build begins :)
- Where to buy: 3" SS Mandrel Bends
- T3 build
- Oil feed thread pitch question
- intercooler coupler q's
- Firewall intake???
- 1000cc injectors
- Improving MAP signal
- Chucks build thread
- Almost done gathering, need oppinions and advice (maybe NWS)
- 94-95 Link - Cuts on Circuit Board?
- Turbo help
- Where to get mating connectors for '01 stock coils?
- where'd my boost go?
- Building track car need advice
- Anyone around detroit know a good place for ABS?
- Built Engine Max Boost
- can i put this ibjectors in my miata turbo 95
- How Should I Build My Cold Air Intake?
- How much audible flutter/surge is normal.
- 14b on a 1.8 did/do you like it?
- DIY Heatshields In Progress
- How to Make a Loud BOV Quiet.
- Interesting A2W Intercooler
- Turbos
- Finding a TD04
- DIY oil cooler
- Dyno Tune
- Guidance before I start ordering parts
- Iat
- Project finishing questions!
- Turbo manifolds please help
- Good turbo manifold
- source for DSM compressor outlet flange adapter
- air-chilled water intercooler?
- Polycarb water tank and SS braided hose kit
- DIY Dual fuel rail
- ebay turbos
- I finally got pics.
- Garrett M24 Worth the effort?
- someone with mazdaspeed discount
- Top mount air filter options?
- Plugs
- CXRacing Aluminum radiator
- Megan manifold questions
- What other COPs ?
- Which port for WB O2?
- Timing Map comparisons
- Toyota COPs in '01 valve cover
- Do I need a MBC?
- Braided Stainless Heater Core Hoses
- Stock FPR questions
- I want a Turbo. Have a Few Questions.
- How fast can a fuel pump die?
- Patsmx5's 20x12x3 P/S & A/C Friendly IC Write-up
- Advice on DIY parts...
- Custom Downpipe need alittle help
- Went for my first drive in a long time...
- broke my turbo
- HKS manifold studs? What size?
- Oil "tee"
- IAC bung
- best place to buy Innovate LC1?
- My progress after a year
- Frozen and stripped Exhaust nut
- NA or NB which is better to turbo?
- DIY'ers need advice fabbing SS exhaust
- Chinacharger - seal leak???
- My first turbo kit!!! help!!
- Found my oxygen sensor problems
- Turbo gurus, guide my cash
- in my frustration...
- cheapest source for AEM F/IC?
- T3 Turbo (Volvo 740) Downpipe
- Look at what I did today (diy IC pipe)
- largest t25 inlet turbo
- Junkyard Turbo Muddle
- It"s alive!!!!!!!!!!!
- Leaky fittings
- Ramhorn manifold
- dual port actuator experiences?
- Someone get this
- Heater core lines for turbo water lines
- Pictures Wanted!!
- injector cleaning fee? reasonable?
- Decisions, Decisions...
- Turbo Heat Ranges?
- My DIY "Budget" Turbo Build
- Intake Manifold Modification... And more.
- Patsmx5's Intercooler Install *56K, no.*
- Looking for flex tube for 2.5" downpipe
- Patsmx5's "General Stupid Questions" thread
- No exhaust gas?
- Electrical plugs for the Miata?
- Quick question regarding injectors and boost
- td04h-15g downpipe flange/new DP
- Turbo questions
- Flange types?
- Taping Oil Pan Need Some Advice/Pics
- Where to buy 1.8 head flange?
- plug and play 440cc and 550cc injectors
- my 1600 gt2876r setup
- Ford probe turbo
- ok need some help...
- Ebay Manifold?
- Greddy downpipe
- Custom downpipe sizing
- My DIY mani
- Busted fitting in the turbo
- Vmount or new radiator?
- 10 Assorted bends
- My BEGI DP
- Tunertoys oil kit
- Quick Preview of The Setup
- Super Cheap build, need some help and extra eyes
- this is a stupid ?
- Need you guys help
- Finally got a Manifold done
- 96+ oil lines
- Clarification on Turbo Flanges
- So off goes the last part of my Greddy kit!
- Mufflers
- Apexi AVCR or Greddy Profec B (Boost Controller)
- GM boost solenoid failures? (please chime in)
- heat wrap for heater hose
- t3/t04e Hybrid in t3 compressor housing
- 2.25" coupler, can it be "forced" to fit a 2" and a 2.5"?
- rx7club rocks
- Is this going to work?
- Who sells exhaust manifold flanges?
- Do-overs?
- VVT motor + turbo + 91 octane owners, pipe up!
- What do you guys think about using VW 1.8T Coils?
- TD04L-13T a good match?
- greddy manifold question
- Which turbo
- 4-5psi Wastegate acuator ?
- That port underneath the throttle body...
- My DIY turbo setup.
- How to test my COP.. Does anyone have any spares?
- spark plugs again. turbo app
- Turbo too small?
- some really good IC info
- sandwiching, not enough flow?
- Coolant Reroute Required?
- GM EBC Solenoid refresher
- 309L filler rod
- dumb oil pan drilling question.
- how much boost on stock NA mx5 1.8 engine ?
- Need CAD drawing me too!
- Intercooler Piping Suggestions
- Holset 35
- What do you want???!!!
- Mt.net opinions ;)
- Changed trans fluid - is this bad?
- 1.8 tb on 1.6
- Stein's Build Thread
- Help out the New Guy - Please
- My parts list/questions. First turbo build.
- How much of this fuel issue do I need to fix?
- just bought a T3
- Is my turbo fizucked.
- Tweeking FM
- Intake Options
- Can Someone ID This Turbo
- SR20 t25 oil feed adaptor?
- Cpt. Slow '95 T3 Build
- Upper hose for tilted radiators
- Quick question.
- Westach for the win
- over the radiator intercooler pipes on a NA ?
- In for real now
- Grounding COPs
- Manifolds swapable?
- Injectors?
- BOV on the Intercooler
- comments / criticism on this setup please
- Intercooler question.
- Where to get turbo blanket for T-25?
- Oil Take Off and other small pieces (plus questions)
- Corksport manifold???
- what's your egt readings?
- Need some catch can answers
- Need Some Manifold Suggestions.
- T3 CHRA rust
- Max. operating pressure or working pressure?
- is it possible, 13's?
- T3 Turbo Housing crack
- New DIY turbo setup from Greece
- Cant clock this pos t25 *rant*
- Planning my new build
- Quick Newb Questions
- 3" exhaust prior to install
- butt joint style exhaust band clamp
- intake manifold project on the cheap-ish
- Massive paper on improving turbo response
- I looked but couldnt find it.
- Quick but relevant to forum question
- Is this downpipe worth using?