View Full Version : DIY Turbo Discussion
- oil pressure gauge no signal bad?
- Schwitzer S200 Opinions?
- Who will be the first twin EFR?
- Coolant reroute ?
- Segregated Downpipe Slip Joint Question
- CSF Intercooler
- Run what I have or upgrade?
- build thread attenpt 2...diy manifold and exhaust
- Need advice IWG/EWG, Axial/Ramhorn
- 1991 Miata DIY turbo build
- A few questions about boost control, fuel managment
- 1.6 downpipe/exhaust vs. 1.8 downpipe/exhaust
- exhaust reroute out driver side fender?
- AMS 500 EBC
- Innovate LC-2 installation in progress - wiring guidance requested
- DIY turbo help me
- Will MSM exhaust fit turbo kits?
- BEGI Garret Turbos VS Shanghai Turbos
- 3" exhaust or reroute
- MattPasta's DIY Turbo Build.
- Slower closing BOV
- PO had no clue what mods have been done to this car.. Please help
- I am NO mechanic but...
- Any Twin Scroll experiences?
- Carnut's build
- Trip to the dyno tonight
- Thoughts on final product except ( the no air filter part)
- Vac line for BOV
- cheapish used Setrab coolers
- BOOST NOOB tax return turbo build!
- Lets talk turbo spacer with EWG
- Educate me! Need turbo knowledge
- Oil inlet fitting...
- Finalizing turbo purchases. EWG or IWG mani.
- downpipe not matching up... ideas?
- What the eff am I forgetting?
- Ceramic Fins on TT set up
- Intake Options
- DIY: Oil pan drill vacuum
- Warner-Ishi-IHI T3 Turbo 51T 21
- Cam Timing and Lowered Compression
- Any knowledgeable DSM or Mitsu turbo guys? Need confirmation
- Plumbing the turbo
- help wanted new turbo project
- FIC SP line- anyone running them?
- Running without a tune temporarily
- Intercooler pipes are through the hood...literally.
- Rust inside steel Begi intercooler pipes
- turbo hp question
- question on my deatschwerks dw200 install(not on a miata)
- Suggestions on Turbo resizing invited...
- sr20 t25 diy assistance
- No power at 2700 rpm sputter sputter HELP!
- Concise guides to putting it all together
- Your turbo coolant lines are all f*cked up?
- Trying to source a few NEW Miata engine harness plugs
- How to wire MS3X with Automatic Throttle Body VTPS?
- 300HP Miata budget build?
- Is premature #3 piston failure "normal"?
- How-to: pipe bending (with tool info)
- "Ebay" pipe kit modifications?
- Aem wideband
- Magnaflow muffler install
- turbo manifold question?
- Turbo Coolant/Water Line Size
- EGR delete
- What do you think of this pre-used kit I found?
- How-to video on the application of lockwire
- Lets Discuss my Boost Creep.
- HELP! Car shuts off when driving!
- Smoke test, passes through CHRA?
- Looking for the right IC setup
- Opinion on this kit I found
- Large turbo on ebay log manifold?
- Low psi build. Trying to get my feet wet with room for improvement later.
- new turbo or replace the center section
- How outdated is Maximum Boost by Corky Bell?
- Need some advice on "Godspeed" turbochargers and GT2554R equivalents.
- DSM T25 Turbo Help!
- 5/8" oil return line, pre-formed 90 degree?
- My Spark Map now with "Death Cans" :)
- T28 turbo
- miata hits wall under boost
- Is this Corksport manifold w/IHI turbo's?
- Custom manifold - loooooong runners!
- Any info on this craigslist manifold?
- Overboost Issue
- 7mgte injectors?
- EFR 7163: The new hotness
- do I really need bigger injectors?
- A Couple of Problems, Mainly Spark Related
- 1.8 swap, keeping TD04H
- Water Cooling Routing - Am I doing this right?
- 2003 Shinsen build
- Turbo ITB BLASPHEMY
- Oil Supply to Turbo
- Tired of my ghetto air filter :(
- Square top Intake Manifold
- for the sake of wanting what i cant have
- FIC Injector Black Friday Sale!!! Maybe...
- Pinky's Sweet (Air) Box
- 300+whp 2002 miata custom turbo kit project
- Surely this has been asked before... k04?
- Identify These Injectors
- DIY boost needs DIY AFR/Boost gauge
- 1.6 return line
- Stock internals for 2001-2003 Miata
- Heater hose relocate ideas
- Hold my hand, and show me how to feed my turbo
- WTF is wrong with my car. AKA why is my boost so saggy V2
- Manifold Woes
- Noob with a turbo plan!
- LSx coil mount you say?
- Subaru style Gauge pod
- Why the f*** did I install a M45?
- I'm confused about how these manifold to turbo studs are supposed to work.
- Tell me what kind of manifold this is!?
- My 99 miata tur...I mean Eaton M90 build
- Low, Rearward Mount?
- Lets talk about air filters...
- TD04 rattle @ 3-4k rpm when over run
- strange leak between manifold and turbo exhaust housing
- Old School S-AFC (5-Knob) on 1990 NA6
- Front leaking oil seals or valve cover ?
- Exhaust/Turbo flange port match?
- Exhaust smoke with high oil consumption
- SR20DET turbo w/ Flyin' Miata maifold
- Should I upgrade my fuel pump?
- Further Thread on Oil Supply
- Manual boost controller bad ?
- Be A Pal and Help Identify This Turbo Flange
- Thinking narrower rad for air intake path ?
- What happens when you fit too big a compressor wheel?
- Baffled by valve cover baffles !!
- intake manifold design....
- Mercury Capri Turbo setup on a Miata 1.6?
- More power but still very reliable?
- Turbo noob seeking advice
- water injection question
- Confusing boost creep
- To many oil pump choices
- NEED HELP MS,GREDDY KIT,METH WONT RUN
- OK place to dump my EWG?
- What's a good price for ceramic coating?
- GT2560R Compressor Housing CNC Machining of Hose Connections
- Intercooler piping setup
- MSM Engine & 6 Speed Swap Into NA
- Drilling the Greddy for 10mm question.
- Lets argue about VGT/VNT Diesel Turbos on a gas motor.
- You guys have to be the ones i need to go to for advice.
- Sourcing BOV bypass hose
- Block oil feed port bad?
- I AM BOOSTED...but I have vibration ;)
- NB intake flange.....
- Possible to replace the BPV with a BOV?
- AIT sensor and bung question.
- 2JZ mani stud question
- Used Kit (Experienced advice needed)
- oil feed/oil galley plug
- ar 70 big turbo stock block???
- Too big? 20g and 1.6?
- First turbo build
- EV14 injectors- Is there a definative list of what comes what from the factory?
- Begi Shanghai or DIY setup?
- Mods before Turbo - I did search, honest!
- DIY Catch Can Question
- First turbo start up
- TurboSmart In-Cabin MBC
- TurboSmart In Cabin MBC
- Correct Outlet Flange sizing
- TURBO ADVICE PLEASE 1.6
- Which turbo blanket for Gredy TDO4 ?
- (Quick Fab) China Manifold Replacement
- Turbo build going full retard
- cheap turbo build
- Downpipe Turbo Flange Preferred Material
- My 1.6 Turbo Dyno Results
- 1.6L 2560 record attempt *SHATNERED*
- Converting NB to return fuel style
- How R you keeping the heat out of cabin?
- A great video on Turbocharging a Miata
- What turbo do you have?
- dsm turbo, what size?
- BP turbo setup fill the gaps
- Coldside piping
- starting my build soon
- Old FM mani and ew fitment issue
- Cops to stock Coilpack
- 1.6 or 1.8?
- Installing artech/absurdflow style DPs
- Why is my boost so saggy?
- DOC Race Manifold
- what would you pay for a begi garret set up
- 03 VVT MAP Sensor Location
- Need Opinions for DIY Setup
- Turbo to hood clearance
- NA1.6 Stock internals... advice please!
- 96 Miata worth the price and turbo'ing?
- Miata wont run
- Pre vs Post intercooler BOV location and optimal air filter location
- fm turbo kits 1994
- Mocking up exhaust manifold
- V band exhaust housing options?
- Maximum Boost??
- which thermostat for turbo 1.6?
- Homebrew turbo question
- Howling when spooling, and turbo shutdown noise. Dead turbo?
- Question about this particular blowoff/bypass valve.
- T25/T28 Used Costs
- Sounds like misfire after begi fmu and bipes install
- Newb needs assistance wth turbo kit
- exintake mod
- ever seen this manifold???
- Anyone know what flange this is?
- How to Turbocharge your NA for 2k, build with TONNES of pics and info.
- What to do with a Turbo after spun bearing
- Turbo fitting manifold database?
- Norgren regulator - anyone using one?
- question/discussion for you turbo wizards
- Budget Turbo Build
- Compound boost: EFR 7670 into Coldside FFS W/ H20/Meth into 10.5:1 VVT Built Engine
- churbo rebuild kit
- Custom 3" exhaust or pre-built one. Help needed please
- upgrade intercooler or exhaust
- Exhintake swap for a future turbo setup
- DIY: raised fulcrum short shifter
- HX30W and low boost on an NA 1.8?
- How much boost can I run?
- Greddy TD04H V-band leak
- donations are accepted:)
- How much do T25s usually go for?
- Wastegate flapper / flange contact
- TD04 vs GT2554 vs GT2560
- Biohzrd's GT28RS Build - From The Dark Side Of The Boost
- Ebay is sometimes awesome...
- Shutting my BOV up.
- Just bought this mani did I use profanity in a thread title?
- miata turbo, white smoke idle issues, the lot...
- CHRA thread sizes
- getting feet wet
- Another DIY build
- Cooling... Reroute on a 1.8 with no Heater Core
- 1.6 build not running right
- locost mx5 project
- Oil return line size question
- Are banjo bolts needed
- Engine apart for big maintenance. FM2 Turbo. Coolant line questions, please help
- explain this wga to me
- capri xr2 stuffs
- driving boosted with no form of tuning..