View Full Version : MEGAsquirt
- Diagnosing a bad coil circuit?
- Tunerstudio MS alone or get Megalogviewer too?
- diypnp sequential
- I keep killing cam sensors, or something...
- LS Coil question
- Test mode MS
- MS3X VVT - no crank and cam signal issue
- MSM w/ MS3 not stating after winter storage
- 90-93 DIYPNP fab9 coils tach
- Base map for 1.8 swap
- MS1 Tuning help needed!
- 04 MSM, MS3 PNP Pro 3. Idle and Pulsewith Issues
- 1990 Mk1 1.6 Eunos - Help Needed With Megasquirt Ignition Setting Nightmare!
- Noobness - first fire: poor response off idle with no load.
- Questions for Best Setup Megasquirt Install
- Higher boost, help with timing map
- AFR worth worrying about...?
- WOT 4th Gear Dies
- cops ms3x 1.6l
- '99 MS3+MS3x No Start
- Check my spark table
- MS2 Volt drop + Mental AFR readings
- VTPS not working only with car running
- VVT swap with Rev MS3, no start
- Hi-res, cap mod, table scaling and more
- MSPNP2 AFR Reading odd
- Need help
- High Idling Problem
- Noob struggles SURPRISE!
- MAP sensor reading ~97 kPa all the time
- Inclining Idle after Startup
- Mspnp gen1 compatibility issues with Traqdash
- EBC Tuning on 1.4
- all calibrations not shown in tunerstudio
- Help, MS1 V3 No Start
- miss fire after fitting megasquirt.
- GM IAT settings for Tuner Studio
- Issues around 4000 rpm while in neutral
- megalogviewer hd no afr's
- nb1 ms noob here
- 2000 Miata brain built MS3. Idle issues/ give my tune a look?
- ms2pnp not switching fuel pump on
- megasquirt help needed!!!!!
- VVT Swap on Rev MS3 ~ No Start
- Lean spikes and stall on light throttle
- Virtual Dyno issues
- Can my "tune" be improved? any feedback guys?
- More NB/MS2v3.0 questions
- Just got my MSPNP2 Need help with AFR
- another 95 tach mystery - rev ms2 basic
- Hesitation and erratic AFR under part throttle
- NB Boost sensor (Factory MAP sensor) calibration
- MS noob, vtps help!
- Ms2 PnP Rev built Problems
- MS3 Basic 6000 rpm backfire and check engine light
- PnP2 injector signal
- All of the sudden leaning out everywhere
- Knock sensor for MS-II
- Lc-1 w/ dx16 and TunerStudio setting a wideband
- Idle strangeness during warm up
- Exocet Log File
- Over boost cutting in?
- Low RPM signal, no spark
- MS DIYPNP v1.5 - EBC & IAT - MAF harness
- Mspnp2 Miata cranks but won't start
- Windows 10 is great; I'm dumb
- Tuner Studio not reading wideband
- Closed loop boost control starting numbers
- Couple quick questions!
- OH joy the gremlins are back 04MSM. MS2+
- No Fan, Idle Valve, or Tach
- ignition banks uneven spark
- Determine which coil fired from log
- Launch control in DIYPNP
- diypnp and VVT
- Double check my ms3x build
- Pre-install check + Questions
- Fuse for Coil packs, which to remove for Firmware update?
- New MS3Enhanced from Rev, general questions
- MAP jumping up and down - help needed
- megasquirt seeing double RPM
- Firmware Update Changes Knock sensitivity?
- DIYPNP '91 MX-5 Doest start
- VVT Swap w/ MS3-Pro & Frank's PCB: no start, please review settings
- 94-97 1.8 swap using Megasquirt
- Tuner studio 2.9 beta released
- Voltage drop while under load and idle?
- TPS problem 94 chassis
- help getting started
- Mistakenly bought a MS DIY kit right before they redid the website. In over my head.
- MS3x R17 only has 2.25v
- Questions about alternator control in my Exocet
- Idle issues with new MS3 install
- Worlds ugliest MS3Pro Module install
- MS2 Excel Calibration Tool
- ms3x ebc kind of working
- BT disconnects during cold start cranking
- Miata Specialist in Jersey Area
- Lean spike at low RPM with partial throttle
- Help with identification
- Mspnp idle issue.
- Req fuel wrong, extrapolate map?
- Ms3 Basic - Brake Pressure Sensor
- can you put the megasquirt in valet mode?
- Megasquirt baro correction/fpr reference discussion
- Bought a Miata MS3/MS3x kit to use on a 240sx, know if I need to change anything?
- MS2 V3.1.0 Connection Issues
- It Runs!....but
- 3 issues with Rev Built MS3-Basic
- Shadow Dash MS with Rev built MS3 Basic?
- Ms1 extra no fan control and high idle
- [NB]Throttle body and MS question
- Engine wants to die on de-acceleration prior to CL
- E85 Information Nightmare
- IAT sensor reading high (not heatsoaked)
- CEL flashes for knock, stock Miata
- Hard/No Start MSPNP and low idle
- Need Rev MS2 Basic base tune help
- Warm restart and idle issues
- Ms1 extra only 2 cylinders sparking
- Intro to tuning
- Dual VSS Inputs
- TIP 120 alternative connection points ?
- 1 warning light, 2 outputs?
- ID 725 settings
- DIY PNP No Start
- Tuning Idle Valve MS2E Rev build
- Fuel Ve Values Really High
- Adding Launch Control to DIYPNP
- MS3 PID Idle Target - Why does it change when returning to idle?
- VE Table axis settings
- MS3X install help
- help - Ms2 Final Checks Before Plug In
- Using the stock 1.6 TPS
- New MSM with MS2 enhanced ECU
- MS3 Rev - No spark - Help!
- Looking at buying a MS from someone
- $5.43 to a helper
- AEM UEGO sensor offline MS3 issue?
- 1995 Miata - MS II V 3.0 (DIY EFI) - Running MAF
- Purge valve solenoid control with MS3-Pro?
- Not your usual timing question
- I think my ASE is all jacked up...
- MS1 on my 95
- Naturally Aspirated motor with a Megasquirt ECU
- MS3 RPM Dip
- 99 N/A Miata- MS2 install-blowing men
- Closed loop- only on starts...
- Wrong Code Loaded?
- Use 90-93 MS on my 95M
- Communication port fail
- ITT We discuss Megasquirt Firmware Releases
- Miata wont start after short block swap
- MAP sensor failure / sticking?
- 02 vvt diypnp no tach signal
- MS3 onboard USB-2-serial with OSX El Capitan
- NO START - 95 Miata DIYPNP - RPM/Voltage drop?
- Help me pass emissions
- MS3 .ini file
- Seq inj 96-97 pinout...
- MSPNP2 not getting power
- got it running but its being funny (datalogs and tune file present)
- looking in the wrong place....
- Thanks for your continued support- CL Idle question
- $130 Bosch 4.9 sensor CAN-bus WB
- MS2 enhanced boost control circuit for VVT control
- Noob here... MSPNP2 Pin Out
- DIYPNP Advice
- 1.6l ms3x sequential fuel
- DIYPNP sensor noise & grounding
- 2002 to 2000 Engine Swap, tune changes?
- bigger injectors-keep same tune?
- MSPNP1 error messages
- MS2 Wont Idle or Rev over 1K
- Stalling right after a start
- BP4w nonturbo ignition map
- MS3BASIC output issues
- Okay- I know I should be able to find this via search, but I can't...
- Megasquirt pnp2 engine gets flooded as soon as I turn the key
- Easiet way to log/VEanalyze?
- Planning my VVT swap
- Feedback desired!
- Gas mileage?
- DIYPNP first start unsuccesful
- Two Questions after DIYPNP assembly.
- sync loss
- A couple of initial logs- was WAAAYY lean....
- Sync loss while cranking.
- Running lean AFTER throttle blip
- Running lean AFTER throttle blip
- How lean is too lean at 4k cruising?
- help wanted to get ms 2.2 running in NB
- Brain built MS3 install- QQ on connection
- Reverant MS2 help wanted
- MSIIDIY 1.6 Initial Start up sounds like a WRX - Misfire?
- High VE Table after New Intercooler
- Aem to Microsquirt
- Mspnp2 1.6 wiring option
- Closed loop idle too early?
- Flex fuel sensor reading high
- Recently purchased Turbo Miata, need some local help
- MS2 1.6 Fuel Pump Mod on SPR4?
- New MS3 Pro plug & play adapter boards
- Anyone wanna sell me a mega squirt??
- Fuel pump shuts off at low RPM
- Help! Ignition timing on MX5 Turbo, MS2PNP
- Help with MS3 base tune
- TunerStudio CAN exchange log?
- No tach ms2pnp
- EBC duty cycle never changes
- MS2PNP & Sequential Injection
- How's MS holding up to weather?
- Sixshooter's Brain-built MS1 Needs to Control WI
- diypnp ignition advance problem
- MS3 no-spark (REV built)
- Stutter at 5k and I just can't figure it out.
- Random deaths issue.
- 6 position boost control
- ms2pnp 1995 mazda miata fab9 c.o.p
- I think it might be in the tune but i'm really not sure
- drifting timing with rpm
- 99 turbo issues
- AFR gauge reading for wideband in Tuner Studio
- Radiator fan always on - driver side
- DIYPNP firmware/base map compatibility
- MS2 No Rpm
- LS2 Coils - Any change to cranking dwell, spark duration, dwell/battery correction?
- Stumble at 6psi plus burbuling
- Used Megasquirt 2 and harness testing
- idle dip after light rev
- Upper limit kpa
- CL boost control has me stumped
- Pnp2 not seeing variable tps signal
- Megasquirt wont A/C Idle up
- MSII DIY kit help - please help a noob
- Mega megasquirt fail 65k rpms
- ISC valve issue?
- More fail cyl 2 and 4 dont seem to matter
- 1.8 BPT MegasquirtII No Tach/CAS
- MSPNP2 Vics Control
- AFRs read rich and car bogs on acceleration
- AFR bouncing all around
- Tuning a DIYPNP in a 90's 1.6L
- Rev MS2 Enhanced - Car stopped starting, can't connect to ECU
- Ok flame me but idle question
- 99 turbo map
- Sequential vs. semi-sequential fuel in MS3
- Sequential ignition with Rev MS3 and Fab9 CoPs
- Megasquirt installed - no CAS being picked up
- How to get AC idle up to work on an NB