View Full Version : MEGAsquirt
- Anyone have an msq for a high compression 1.8?
- Help Needed with noob trying to megasquirt
- MS-1 for 1992 turbo build question/confirmation
- Rev limit and high idle
- table switch (or launch) without daughterboard modification?
- In search of NW ms3x tuner
- What is the MOD to run the Megasquirt off of one Temp sensor
- Building a custom wiring harness, questions
- MS2E startup issues
- MS3 + Fab9COP = no tach
- 1.8 stock injector deadtimes? help
- '90 w/ MSM swap first run/troubleshooting
- DIYPNP, -99 1.8 NA (euro) | Battery charging malfunction
- engine runs good, idle still wacky (sucks)
- Can I run semi-sequential on a 1.6 without changing wiring?
- MS3+MS3X Stopped working - No Cranking/RPM Signal
- Variation in TPS each time I look
- Deatchwerks check in here
- Heater fan does not work after MS3/MSx
- MS3 Install '99 Miata
- why my idle is so bad
- Won't start when hot
- Few more questions now that my car is running on MS
- a HUGE thanks
- MS2 Basic starts then immediately dies
- Req fuel constant question
- VVT setup and test procedure - help please
- DIYPNP jumper questions
- Need some tips for my tune
- MS2E: Runs well, but won't rev past 4000 rpms
- Trying to get started with MS3x
- VE Table?
- How do I tell if boost control is doing anything?
- So, car is running, went out to do some log runs.
- Upgraded to MS2 having erratic rpms
- Fluctuating idle due to Open Header and no intake?
- couple of questions
- (Batch fire) Only cylinder 2 and 3 has spark, but not 1 and 4. How to correct?
- How is this engine even running??
- Why are my datalogs so inconsistant?
- Installing ms3x...crazy noise when key on...
- I must be stupid or something. MegaLogViewer?
- Reverse firing order
- Need Help with launch control!!
- Car Sputters hard, msq attached
- Switched from MSPNP1 to BrainMS3 and fuel pump no longer primes
- Car starts, runs for about 5 seconds then dies
- No crank signal - with 36-2 trigger wheel
- MS Labs MS3 basic EBC not working
- switching to linux-keep registration?
- AEM wideband sensor install without gauge
- Boost Table - How to get it close to perfect
- DIYPNP vs MSx and base tune?
- Why does my T.S. look different than eveyone elses?
- Questions on Rev built MS2e
- Misfire, or terrible tune? MS2E (Logs+Tunes included)
- Help Wiring MS3/MS3x
- Fan VSS shutoff not working on MS3x (JimStim)
- Cold start - First start always stalls
- MS2E AFR Table not saving
- No injector output - Bench testing MS3X
- There she blows: DIYPNP
- I cannot control Idle, tune & log attached.
- DIYPNP Wont Start
- db 15 diagram
- MS2 no start, no spark, no rpm signal
- Idle
- ‘96-97 DIYPNP Jumper Visual Map
- What is needed to improve crank signal on 96 engine
- MS3X testing with Jim Stim - No RPM Signal
- Boost Solenoid Output Pin? - Reverant Enhanced MS2
- Reverant, 1.3.0 FW?
- spark angle noise?
- MM9900PNP install on my NB, issue with neutral safety switch...
- need help fuel pump on diy ms2 2.2
- installed mspnp car cranks but wont start
- Wants to stall when starting, runs fine once running otherwise
- Naturally Aspirated AFR table, check mine so I dont waste time
- VVT, sequential spark and 36-1 trigger wheel
- It's Aliiivvvveee!!!
- MS2 pulling timing under load/throttle
- Help with my reflash!!
- Where is place to buy megasquirt ECU
- 1.6 Switching to 36-1 setup
- Please help ECU MS2 N122
- ECU doesnt seem to hold tune
- Intermittent Fuel/Spark Issue - Need Help
- swapping from Ms 1 need help
- Swapping stock motors with already tuned megasquirt
- What are your afr calibration points for aem 30-4100 wb
- AIT sensor Acting up
- Evaporative Emissions
- Help with fuses
- Having some issues with tuning 02 sensor off
- Fan always on but Warmup LED switches on and off
- Reverant MS3 basic - winter upgrades now won't start
- Injector characteristics?
- MS2 - Can't make real time changes?
- My spark table.
- Need Help with IAT sensor not reading
- MS3X harness check. (Flyback Diodes)
- Car Idles at 4000rpm Please help
- Calling all megasquirt geniuses I need your help!! 2jz Megasquirt EMS Pro
- Dwell settings for 2001+ coils
- Igniter keeps failing mspnp2
- MS2 no communication with computer
- help with ms2 in maryland
- 2001-2005 DIY megasquirt build documentation?
- MS help in San Jose, CA
- Megasquirt wont power on, am i ******?
- 95 Body, 96 engine.
- help fine tuning cold start. starter kicking back/stalling
- Help with fuel tuning/ required fuel
- MS2 3.57 Relay board: Ign outputs via IAC
- PNP2 engine swap question.
- MS2 - seeing the settings without the car...
- Tune erased on MS1 3.0?
- First time MegaSquirt user! (first time tuning too...)
- Tune erased on MS1 3.0?
- does anyone have a 3.3.1 firmware base map for 1993 miata?
- high idle right after startup
- Need help getting my MegaStim in order, TX
- I'm stoked I could fucking scream!
- MSPNP2 cranks but wont start
- Issues with Oil Pressure Gauge/Sender & MSPNP2
- Help wiring the MS2
- TPS calibration value=0
- MSPNP2 95 Launch Control active while driving
- Launch Control
- 1999 Miata / new DIYPNP - runs as stock - pops but won't start with DIYPNP
- Making an ignition table more conservative - need feedback
- Newb to MS3 any help with improving tune appreciated
- trouble setting base timing DIYPNP
- Strange Results of Injector Change
- Putting ECU back in after months?
- MS3x Issue - Programming SPK & INJ Outputs
- MS Installer/Tuner in Jacksonville?
- Key on/engine off MAP readings out of whack. Should/can I recalibrate?
- MS3 pro module PnP adapter board
- Cold Start Enrichment Tuning
- Ok to remove rear O2?
- Easy fix for AC compressor with a MSPNP gen1?
- Looking for a basemap for MS3X
- IAC and CL settings
- Useful Megasquirt Tutorial Videos
- Megasquirt Boost
- Does anyone have miata with megasquirt installed in topeka, kansas region?
- Good laptops for tuning purposes only
- N/A 1.8...changing project properties & outputs ??
- Not as much power than before with 99/00 head
- Help wiring TPS on 1.6
- Help choosing crank trigger wheel and how to wire crank sensor
- MS2 3.57 help with modifications before install
- Jim Stim and 1.5b N76 Board
- Installed FIC 900cc Injectors, what to change?
- basemap for NBFL 03
- Clarification of I/Os in MS2 and Sequential Shift Lights
- BEGI EV14 550 Injectors
- MS3 Starts/Runs rough, Rich as $%#$ nothing helps
- TPSdot fluctuation on idle
- Megasquirt dying/losing connection after running for ~20 seconds
- Knock Sensors/ Det cans?
- Aligning AEM WB ad MS3
- MS3 Installed, car runs like a dream
- Anyone want to take a look at my tune?
- MS3 dwell settings for 01+ cops?
- My issues your help
- Help tracking down MS3 wiring issues/diagram
- Does MS2 support WI?
- MS and the Mitibushi sensor
- Lean start & Knock Sensor
- MS3X install no start
- Fuel pump circuit
- MP62 Ignition Basemap
- Couple quick questions...
- just wired ms2 and couple of issues
- MS2 vs. DIYPNP
- 93 miata MS3x with LS2 coils, 99 tps and iacv setting
- AFR targets for 98octane pump fuel
- MS3X installed..car wont start...
- Noob question r43 ms3x build
- Can a DIYPNP tach output be used to correct the Dash tach?
- DIYPNP2/95Miata wont start.. .msl uploaded
- Anyone have a copy of Brains Megasquirt install pdf?
- MAF delete
- Megasquirt 1 no spark, 94 Miata
- Ds1's Horrible ECU Tuning Thread
- Not again! Another person habing com (and kebyord) pronlems
- New MSII build - tach problems
- So I have an MS3 basic. Now what?
- Fuel inject run out of control
- DIYPNP Idle Issues
- OBDII, Emissions testing and Megasquirt
- No AC after fw 3.3.1a (?)
- I want a cookie for my cold start!
- Fan Control on MS2 Enhanced (i.e. Rev built)
- Misfire at idle
- Problems regarding idle ms3
- How to use TS and Firmware Upgrade OS X
- Which Megasquirt is right for me?
- Tunerstudio (2.0.8)
- Want to buy a MS3, I think
- MS only fires on cyls1&2 or 3&4 with COPs
- MegaSquirt tech support job opening in Atlanta area
- MS1 v3.0 no spark or injector pulse. Compuer connection OK.
- AFR problem. Runs lean and fluctuating
- Tunerstudio won't load basemap - 'null' signature?
- Very high idle problem
- Very high idle
- No RPM - MS3/MS3X 1.6
- MS3 and MS3X wiring questions
- Half Finished ECU -_-
- Megalog Viewer Status Annunciators
- Dash tachometer will not work, tach in Tuner Studio works fine...
- Frank's MS3X/MS3 starting msq for a 90-93
- Does anyone have an old MS firmware reflash program with firmware v3.2.1
- Connecting to computer on the bench but not in the car
- MS1 Brainsquirt No Spark No Injectors No Comms with Laptop
- HELP! DIYPNP almost destroyed my car
- Not understsnding AE function in Tuner Studio
- Book for learning MS ???
- Re-Flashed Ms pnp2 - no spark on cyls 2 and 4?
- Jbperf and Frank MX5 Westfield MS2 Questions
- studder around 5k
- My OWN thread about my OWN MS3x idle "issue"
- Replacement CPU for MSI
- Just want to see if I am getting this right
- Knock sensor never goes above 20% - Normal?
- No MAT vs Fuel map ? (DIYPNP)
- Who's Using MS for Track Data? How? Ben?
- DIYPNP idles fine, stalls when throttle applied
- delete
- DIYPNP (will not burn tune)
- Check my Track Tune Please
- Megasquirt tuning issues :/
- DIYPNP Help//Built but wont connect
- Hold my hand while I wire up this MS2 3.57 to my friend's 91
- How to Mount MS3X in 90-93?
- MS3x base map
- MS2 Sync Loss/Fuel Pump Relay Reset
- made my own canbus gauge
- what does this warning mean?
- MS3x How does my Ignition Table Look?
- Stims for sale
- Reverant MS2 problem
- Help troubleshoot my idle please
- MS2 build questions
- Need to find MS tuner near or in Iowa
- Not building boost with MS2E (builds boost with reflashed ECU)
- Finishing off DIYPNP, couple questions (alternator voltage regularion, sequental inj.