View Full Version : MEGAsquirt
- alternator circuit in injector part of pcb
- Cranking help DIYPNP 92 Miata
- Can't get dashpot adder to work
- Baro Correction Sensor Install Clarification
- MS2PNP Total sync loss black exhaust splatter.
- [MS3X] Usual Minimum and Maximum VVT Angles
- EAE tuning
- WOT "Hesitation" @ 8psi - HELP
- Super noob, need help identifying what I have.
- ms3x vr circuit adjustment screw up
- 1st Datalog, what to do now?
- MS3X 1.6 Sequential No Start, No Cam Signal
- lost sync reason 38 (4g63)
- Doing MS3x on a stock 91
- 92 Miata no Spark - DIYPNP
- DIYPNP on 1997 miata - a little help
- Problems with cold starts
- New boost control strategy in MS3 - with initial duty table, how to set...
- Still having issues with it bucking
- I give up, is it flooding or compression?
- DIYPNP Startup Issues - BP4W, 410cc, NA6 chassis
- DIYPNP no start on a 92 Miata
- Learn me how to seq. injectors
- MS3X-1.6 Sync loss @ 4K, high idle
- Injector and Regulator Recommendation
- Reverant Enhanced MS2, whos running one ?
- Odd misfire cruising in town
- Aem strikes again
- Was: Anyone ever clean their COPs? Now: Help me fix me s***
- ITT: VVTuner "piggyback" wiring for stock (or nonMS) ECU
- Cranking and ASE tuning
- DB15 pinout options
- Call me a Volunteer, but MS-ing an Automatic?
- 99- possible knock. Pls. check my ignition table please
- Apexi Boost Solenoid
- 92 1.6l MS2 Tach Input Problems
- HOW TO: over boost/ shift light in Dash cluster.
- Excess electromagnetic interference?
- Reverant Megasquirt for MSM
- Looking for Someone to tune My Car in Virginia
- GM iat alternatives
- Spark output in test mode, no spark while cranking
- Fuel pump does'nt stay primed
- Shadow Dash MS for Android
- Sequential Ignition question on an "MSPNP1.5"
- MS3/ MS3X installed and ALMOST working
- please check my ms2 harness
- Looking for MS tuning help in So-Cal
- No start, much sadness, 99/00 DIYPNP
- Misfire under boost
- Passing CA Smog roller dyno. Failed High NOx, things bouncy.
- Megasquirt install questions
- Knock Sensor settings on MSPNP9900
- 99 1.8 swap in 92 1.6 car
- Fitted 36-1 trigger wheel, firing on 2 cylinders
- Map reading and fuel are way out of wack please help I'm getting 5mpg
- USB Disconnecting from MS3
- Autotune removing fuel
- Android Data Loggers?
- MSPNP1 virgin chiming in...
- 1.6L pnpecu install TPS and ST_SIGN fuse question
- Show me your nonlinear barometric correction.. (MS2/3)
- Lean after swap to ID725cc from 460cc RX7 injectors at correct req fuel
- Startup/Idle Issue DIYPNP, Miata 90 N/A 1.6L
- Strange happenings under (higher) boost
- New DIYPNP install, first start minor issues (Wideband, IAC)
- New Ms3 Style Firmware For Ms2 Users (Diypnp & Ms2)
- Testing MS diypnp to see if it is sending signal to ingiter
- improving my startup
- No RPM/sync when going ms1 to ms2, 92 1.6
- Critique my datalog please, Random RPM spikes and Gair
- Improving my ignition
- IAC valve not working
- MS1 Anti-rev
- Depressing problem.....
- MSPNP Gen2 + EBC + VICS?
- Damaged Megasquirt PNP help please.
- Megasquirt ignition
- no temp gauge after engine swap
- Megasquirt vs Microsquirt for my rebuild.
- MS2 Table Switching - EBC?
- f**up my cars diypnp
- Boost control causing sync loss?
- Ecu Pinout
- RPM gauge and temp gauge jump around after turbo install
- MS not running properly when tunerstudio is off+ random wiper issue?
- Ms1 v3
- DIYPNP with 99-00 style Cam/Crank Sensors
- Megasquirt cutting spark over 100KPA?
- fml no power to mspnp 90-93
- Can I use 99-00 diy base timing map for a 01-05 vvt engine
- large oscillation in AFR at freeway speed datalog attached
- MS PNP 1, can it be upgraded?
- Need tuning help, engine not meeting AFR goals- poor gas mileage
- MSPNP .ini file needed, urgent!
- New tech article: Tuning MegaSquirt acceleration enrichment
- How to move wire in the stock harness?
- She squirted in my eye
- AFR Tables
- No AFM Air-box top
- motor back in, running rich and backfires
- motor back in, running rich and backfires
- First day at the track/ auto-tuning MS3
- Input needed on custom install (non Miata)
- Running lean at partial throttle and WOT around 4k RPM
- MS3x Knock Module Settings Thread
- Trouble going into CL-Idle
- MSPNP 99-00 o2 wiring
- Wells vTPS install
- 90 miata with diypnp running 04 coils
- Megasquirt 2 - no spark
- 255 in fuel table
- Converting an MS1 to MS3... Possible?
- Losing sync only during cranking...
- MS3x how do i hook up launch control/2 step/flatshift
- Check out my spark/fuel maps. Also, flatshift?
- FlexFuel sensor?
- MS driving me to drink
- 04 engine vvt into 90. Need fuel and timing base map.
- IAT sensor in Intake Manifold
- MS1 installed tach not working, already tried resistor trick
- Opinions on these maps for my car
- Help - light load misfire
- Trigger Wheel Setup
- Help with getting Hr_10g to Run copy_ini.bat
- Tuning help
- Continually leaner AFRs
- My timing is about 7 degrees more retarded than what the map says and idle is high.
- 1990 1.6L MS3/ M3x 1st start issue / base timing
- Eriki's MS1 Questions
- MS2: Need a hand with warmup idle
- help! MS3x 1990 NO spark on cyl 2 and 3
- Megasquirt PnP2 99-00 Miata MS2 is here
- MSPNPs for 1999-2000 Miatas are here!
- EBC Settings
- Very rough signal from the wideband controller
- Need ignition map for stock 99 engine with t25 turbo
- CL Boost control PID Failing
- where to find a more detailed MS manual ?
- Finally installed my MSPNP yesterday
- ms3x boost control issues
- Yet another help me get my MegaSquirt running thread...
- Knock Sensor Settings for a '99 with stock knock sensor
- AEM UEGO Full Lean at Idle, Sequential COP Base Timing
- DIYPNP Open loop boost overshoot
- Misfire log, what to check next? MSPNP N/A car
- MS3 with MS3X 96-97 Build
- Injector driver problem (video)
- Okay.. WTF did I do... DiyPNP stopped communicating...
- new to MS, first logs
- Fan/Output4 always randomly blinking
- RPMs dip when throttle is applied and when coasting into neutral
- MS2Extra base files for 1999 NA or turbo
- ms3x install/setup issue
- Reverant MS2-V3, need help with acceleration enrichment and idle A/C settings
- need help megasquirt 1st timer
- about to order MS2. am i missing anything?
- 99 with 04 mazdaspeed, cranked but wont run
- Gauge grounding question(s)
- can anyone ID this MS?
- Where's my power? (maps inside)
- okay, i'm lost.. WHAT do I exactly need?
- Question about discrepancy between AFR gauge and MSPNP reading
- MS2-Misfiring
- Tuning with VEAL day vs night time
- IAT sensor bad?
- spark map: am i an idiot?
- 3.2.1 firmware update and now no tacho in TS
- Calibrate AFR Table question, Why won't they stay?
- Lost on getting my car started. 1.6 M45 w/ MS
- Datalogging with MS?
- Possibly shorted MS unit?
- tuner cable broken. help!
- A/C Idle Up
- baro correction issues
- MS serial to OBD2 connection
- 1994 MS1 going into a late 1995
- Jason's proposed closed loop boost control strategy
- Greddy Kit baseline Tune MSII V3
- Is this normal AFR behaviour?
- Latest gslender mod posted v2.7
- Proper timing and EGT at cruise
- Motor blew up, check out my tune.
- Review my Tune
- Car is tuned, dyno sheet
- PnP 01-05 MS3 + MS3X
- Looking for some base msq's for my how-to's
- VVT with MS3: Need some maps
- MegaSquirt and the shift light
- Reverant MS2 "switch between VE/Ignition tables"?
- Car is idling, what's next?
- How Much for MS PNP 1st Gen?
- MTX-L or LC-1 Is one better ( or worse )
- MS3x A/C Jumper - Please verify
- MS3x installed, tach doesn't work.
- MS2 1.8 Starts, Runs, Revs. What do I do from here? Wont idle. Runs Lean.
- MTX-L GND or SG?
- Megasquirt in... car won't start. Help.
- MS1v3 - JS4-JS5 signal leak. How did I screw things up?
- wiring in launch control to my home built MS1v3.0
- How do you run your vacuum lines?
- Hydra to MS2v3
- Quick stupid question. Does PNP run closed loop?
- 1.6 OEM ecu timing map?
- NB 1.8 idle, basic setting help
- Toyota Cops MS Misfire problem
- I need some MS help
- Enhanced MSII, flashing CEL
- 1990 w/1.8 swap just installed MTX-L
- Confused on IAT
- MS1 1.6 to BP-Z3
- bluetooth to megasquirt settings
- I'm getting closer, starts and idles pretty well, wont drive
- MS2 fan control
- Fuel table question (high load low kpa)
- First autotune- Input appreciated
- Dashpot decay factor? Can't find info the manual
- Is there no cool down fan setting?
- Mspnp2, loaded tune, tuner "cant handle" bricked
- Help me get my LC-1 to match TS A/F
- Revs horrible, runs great wtf
- Smoothing VE tables - Interpolation Spreadsheet
- '99-'00 Miata test mule needed for MSPNPs
- no engine braking?
- Retune boost PID after turbo swap?
- idle issues with A/C
- tuner studio errors on netbook
- How to convert MS2 to stand alone
- blew highside driver no st sign.
- Can my mspnp control water/meth?
- Budget MS build questions.
- no power until 5200rpm
- Boost target table - how does yours look...?
- Critique my tune
- DIYPNP Coolant Temp Problem
- MS1 losing CAS signal
- Weird alternator circuit issue
- Ms1 v3.57 has no tach imput,ms shows that there is no rpm but all other sensors work
- Need help finalizing my MS2 jumper harness.
- Cutting power to the Megasquirt
- Megasquirt on ebay?
- Light throttle stalling/stumbling
- Extreme hesitation under load
- Noob tuning troubles
- Critique my tune please :)
- stalling and VE table question
- MS3 no start, have spark, fuel, not sure about timing
- 1997 tps to MS1 w/relay board question
- Reverant MS unit - no tach / rpm
- Microsquirt help.