View Full Version : MEGAsquirt
- MegaSquirt Pnp2 Coolant fan on Driver side Doesn’t come on Automatically
- Losing boost at high rpm when ebc duty the same
- Megasquirt PNP Gen 1 no spark on 1 and 4
- Closed Loop Idle A/C Stalls
- Supermiata 36-2 trigger wheel sync issue
- Weird idle lately.
- Wiring up an AEM AFR WBO2 to a 2000?
- Odd NB Idle Valve Behavior
- 97 MSPNP2 no fuel in 3,4 cylinder
- Megasquirt or Misfire?
- Bosch EV14 750cc Tune Help
- Brain MS3x no start
- Mtx-l plus erratic behavior
- MS3 Basic error when selecting fields for SD card logging
- What value bias resistor to use with a GM oil temp sensor?
- VVT Swap into 92-Start Issues
- Sixshooter burns up a MS3 Basic (maybe)
- Map Sensor Reading Wrong-Help
- A/C Issues on 96' DIYPNP
- NA Miata MS2 Issues
- Is this the simplest way to add nalogue inouts to MS3Pro PnP?
- 3rd analogue input? MS3Pro PnP 99 Miata
- T/S gauges pausing during live viewing
- Ms2enhanced pnp software help
- Injector Latency Help-Bosch EV14 750cc
- MS2e Trigger Angle Issue/Error
- Obligatory MS2PNP beginner issues
- Engine Bay Clean Out
- 1997 Lean Hot Start
- check out this spark map
- MS2PNP resetting under load
- Megasquirt EFI wiring install help
- Megasquirt Tuning Session Advice
- VVT Tuner Question
- MS3PNP A/C Compressor inoperable
- Anyone with a Pierburg waterpump?
- Help with MSpnp2 + Flowforce Injector = Lean
- 94-95 Megasquirt on 96 Miata
- MSPnP2 AF tuning help please
- Can't get files from SD Card with TS
- Where to get MSpnp?
- Ebc PT7 not working
- Suddenly running lean
- Looking for some tuning help - Northern/Central NJ
- MS2 in a 2001 NB 1.6
- Mounting MSLabs MS3
- Help with 97 Tune
- Build Guide for Megasquirt from Kit
- MS2 NB HELP!!
- Troubleshooting MSPNP2 and possible Idle Air Control Valve problem
- MS3 Pro PNP knock sensor
- 97 MSPNP2 no start after install
- MS2 to MS3 No Start
- Any pointers for making my enrichment and overrun settings not suck
- Aftermarket ECU for sale?
- What shop in SoCal is best for tuning MS?
- strange ve fuel table
- DIYPNP - Relays cycle rapidly, no start
- Msq for 1.6 with flowforce 640cc ev14s
- AFR's lean issue
- MS3X misfire issue
- Laptop connected to PNP1, cranked with low batt, now won't connect.
- VTPS Not Making sense
- Recommend me a serial to USB
- ms3x, got fuel, got rpm, no spark
- Bench testing MS2 Ignition
- Swap issues 1.6 to 1.8 MS2
- 1994 Miata megasquirt basemap resulting in running too rich and high idles
- Megasquirt Sync loss and timing way off
- Need Help
- MS3X NB2 above 2K rpm issues
- 05 NB MS2 VVtunner lost tach under load at 3-4K RPM
- Fuel Pump Pressure Control
- Stupid newb question - MS3X vs DIYPNP2 and other dumb questions
- Crank Signal Hysteresis? No start ms3x
- Trying to figure out how to program fan control on MSPNP2
- Lower timing belt cover needed?
- MS2 PNP facory knock sensor
- Miata stops making boost around 5000rpm
- ITT: Value of TunerStudio Ultra Tuning / Dyno Views?
- need some serious help with ms3 pro pnp
- 1999 [NB] - MSPNP2 Tuning Opinions/Feedback/Guidance
- Fuel flow cc # off ?
- Looking to Megasquirt soon
- Help with Idle MS3X
- MS3PRO vs AEM UEGO
- Failure to Start
- Cant get new build to start. Help!
- Hooked up ms3. Tried to start car. Smoke!
- Help plz Fuel VE values seem very unique...
- MS3x, Custom Wiring Harness, Automatic TPS Wiring
- Help/Opinons with timing map.
- Can Anybody Make Firmware?
- Dyno tuner in NC
- Why is my fuel map boonk?
- Couple MS2 vy Reverant questons
- Idle VE Table Values?
- Plug an play dash gauge for NB (and soon NA) for Megasquirt
- Squirting into a 95
- Help deciper this MS2 board?
- High deadtime, What is going on?
- MSPNP-Pro wont start...
- rich-flicking afrs and stumbling engine
- Weird VVT angle / no start issue
- Odd MAP readings under WOT (N/A)
- Getting 1.8 NB2 knock sensors to give usable readings
- Buying a MS3ProPNP vs building MS3 V3.0 with Nippon Denso 122 Pin
- Still trying to figure out idle fuel
- AFM Removal EMU vs MS3
- HELP New Brain-style MS3x build first start issues!
- If I blip the throttle at idle, car stalls. MS3 NB
- 91 NA MS2 -- 2U and 2V weird voltage
- AEM X series wiring into MS3 PNP 96-97
- Upgrading 2560R to EFR6258 keep same timing map?
- Activating CL based on external inputs
- Unable to connect DIYPNP
- Creating boost blend and bad gas maps via rotary switch
- Sync lose cranking CAS on VVT engine
- Can’t Load Base Map on DIYPNP
- NB TPS on NA
- First drive on MS3 Knock is bad
- MS3x brain-built first start up issues
- Sync loss on good Crank and CAS signal???
- MS2 V3.0 Boost control algorithm issue.
- Hard Crank and lost sync (?)
- MSPNP2 Sequential Injection
- Need timing table for 20 psi and 1.6
- Idle issues
- VE Analyze showing differnet results after every analysis
- DIYPNP - Adding a Boost Control Mod Kit and Running EBC signal through MAF Connector
- Anyone near NJ want to help me tune MS3 and make some $ for it
- where to buy ms in the UK with wiring loom
- Intermittent Sync Loss MS3x
- High load at idle
- 2 Questions for the Price of One...
- i hope this is only an issue with 1.6
- Closed loop idle - Activation and lockout settings
- Quick questions on wiring MS
- Very high EGTs but rich?
- Opinion on my tune so far.
- Fueling issue: 100VE at idle, 94VE in boost
- cop conversion, no spark from ms?
- Feels like dropping a coil, but "resets" with key cycle
- New laptop causing issues.
- Brand new Mm01-05 pnp pro wont flash firmware and accept tune
- DW700 install tuning help
- 94-95 MSPNP Idle Tuning Issuss
- Is there still a reputable timing map that people use?
- MS3 mini recommendable and where to purchase?
- MS3x Wiring Diagram Confusion
- Firmware error running TunerStudio
- Adjust idle RPM in Tuner Studio?
- Fisrt time messing with ms
- Rpm dip/high idle/intermittent hesitation ms2 problem
- Mysterious Fuel Cut - RPM based
- is my EBC working properly?
- Can someone check my tune please
- Knocking on base map w/ 9:1 compression
- Rpm increase when shifting, intermittent.
- WOT AFR wonky
- MSLabs MS3 Basic ADC Input For Fuel Gauge
- Help with base timing on 9:1 turbo motor
- Fan Control Issue
- Start sequence + low voltage
- Weird bump in Boost
- Fuel Cut at WOT, VVT Swap MS3
- Still tuning Idle on my MSM, need some guidance, perhaps in person
- Tuner Studio not recognizing my MS PNP2
- Does anyone have a Naturally Aspirated 1.8 tune?
- External MAP sensor calibration..
- Getting past initial Tune and Bringing in Boost
- n00b question about MegaSquirt and OBDII emissions
- Fluctuating Idle and Decel Problems
- Updating NA Tune for Rotrex SC
- MTX-L connected to TinyIOX gives wrong reading
- Crank No Start MS3 97
- Where to get ECU "Connector 2" for "engine upgrades?
- NA VVT MSlabs MS3 Throttle TPS issues
- DIYPNP VSS
- need help with 96 and MS3X, no start issue
- MTX-L to MSLabs CAN connection
- Help, stranded and lost!
- GM IAT with Deutsch Plug
- Fluctuating AFRs (most noticeable at idle)
- Trouble heel-toe downshift with MSPNP
- VVT swapped NA first start up
- Sync Loss Errors at 3500 at 3600 rpm
- Tunerstudio AFR bouncing like crazy
- TPS calibration problems
- idles fine until i blip the accelerator then dies
- NA6 on DIYPNP, Runs well once started but having startup issues
- Returnless NB to NA Fuel Setup - map changes..
- Injector Question
- Stupid AFM implementation Question
- New to Megasquirt and interested in learning
- Odd ball fan control
- 1.8 swap and sequential fuel upgrade, no start, very frustrated :(
- Rpm surge.
- Noob Tuning Help...
- AEM wideband not sending full voltage to ecu
- Trigger Wizardry
- Mslabs ms2 basic
- Megasquirt misfire issure na6 vvt
- 94-95 MSPNP2 on a 90-93
- Another no-tach issue
- A little advice for ignition, and a first time DIY tuner.
- car will crank but not start 97 ms3x
- 02 Miata MSPNP3 Pro cant get wideband signal in tuner studio
- Erratic fuel/idle on hot restart
- mx5 nbfl 1.6 diy pnp wiring
- Megasquirt Dash Insert Gauge
- Another guy with idle trouble
- Megasquirt V2 - Wacky CLT data? Bad Temp Sensor?
- Help: 92 NA DIYPNP
- Help me hit full boost
- Knock Frequency on 1.8
- Miata dies when clutch is pushed in
- MS AFR Table Interpolation
- MSPNP2 - Swapped a 1.8 from a 1.6 wiring
- Fuel Pump Control Settings
- Closed Loop Boost Control: MS2 Vs MS3
- Trigger wheel for NB
- Famous 1.8 swap, no spark
- Idle Issues - DIYPNP '90 NA6, .msq and log included
- 1.8 Swap, first start question
- MS3 PNP Pro vs Rev's Enhanced offering
- Help with trimming fuel (enrichment stuff)
- MAF pigtail for IAT/EBC (95)
- Hot start throttle hang
- Megasquirt being glitchy
- Yet another NB2 MS3X no start
- 4000 rpm idle
- CANBus Wideband on MSPNP Pro?
- DIYAutotune Base Map / Firmware mismatch, TunerStudio Errors
- High idle after Turbo Kit (1300)
- Launch Control Activation Switch MS3-Basic 01-05
- Idle issues after cold start when nearly warmed up
- How do YOU tune VVT?
- Megasquirt 2 not getting power
- MSLabs MS3 Basic - NB into NA, and add second VSS
- Need help getting the car started after a while
- New Found Idle Woes
- 2000 Miata breaking up under boost
- MSPnP Pro installation photos?
- injectors timing table VS adjust timing based on cam
- Startup/Idle problems after upgrade to MSPNP Pro
- MS choice for N/A NA with BP4W
- Sudden jump in RPM
- Miata with PNP RPM fall 0 intermitanly
- Fan Control: VSS Shutoff Speed and temp settings?