View Full Version : MEGAsquirt
- Injector timing coolant temp based?
- Idle AFR changes
- Properly grounding sensors with a Megasquirt
- How can I print my VE table?
- Random Lean/Rich conditions
- MS1PNP MM9697 Which connector for center options port?
- Older MS3 basic wiring pinout?
- Cold start tuning
- Output test mode not working - Burn Page 1 failed.
- Wanted: MS3 Tuner Tampa Area
- Removing the bushing from a stock TPS?
- Tuner Studio Autotune
- NB2 MS3 Fuel Pressure settings
- Timing issue
- Car won't start, dim battery light when key removed
- Crank/No Start; RPM Detection Issue
- Tips on switch from Miata link for 96-97 to MS PNP gen 1 for 96-97 NA8's
- Losing power
- ms3 / ms3x harness assembly (question on grounds)
- Adjusting Tach Error
- Megasquirt Closed Loop Idle Lockout Issue
- 00 NB w/Aug2017 Rotrex install....NEED HELP!!
- Passing inspection with Megasquirt?
- RX-7 460cc injector upgrade and motor rebuild - Chasing my idle
- We're looking to hire a tech support / tuner
- Any Oklahoma tuners??
- IAC not working?
- Vtps/AFR issues
- WestfieldMX5 MS3 Pro Module Adapter Board Manual
- ms2 diy mx5 10th anni
- Stock ECU and O2 sensor trouble (code 15,17)
- 1.8 Coils
- Miata dies on hot starts, fine when cold
- Car initial startup/idle issue
- Which Megasquirt to buy
- Braineack MS3x 99-00 into a 01-05 Miata
- MS2/Extra 3.3.3 Very Odd isue with boost control initial duty table
- Braineack MS3X EBC
- Alternator probs, experts in electrical needed
- MSM Base Tune with Joe's intake (similar to BEGI) and FM dp/exhaust
- Still no crank on 96 with Ms3X
- Help pls, MS2/Extra strange spark output issue
- Base tune on CA 91 vs Race gas prior to e85
- Miata na 1.6 tuned :)
- 96-97 MS3 Basic 1.4.0 basemap needed
- 96 Miata MS3X Cranks but won't start
- Just another 91 Miata VVT swap no-start
- First Log on my MSM, take a look? yell at me?
- MSPNP2 Running on Two Cyl?
- Safety/Sanity Check (AFR and IGN tables)
- TS reading 5V constantly from AEM UEGO
- Ms2 pcb v3 spark output/mods
- MSPNP2 MM9495 boost solenoid wiring
- Boost Problem
- surging at low load at 1500rpm
- Burned up 5v Regulator
- Check Previous Owner Tune
- Anyone using Limp Modes?
- Boost by Speed/Gear
- How to tune lowest load row in VE Table?
- EGO does not appear to be working
- Crazy rich idle in cooler Fall temps
- Should I Ditch Hydra?
- Switch for lower Rev Limit
- So I "tuned" today ..
- VVT1 error at idle(MS3PnP)
- idle oscillation
- PWM Idle Voltage Compensation
- Seems to run on 2/3 cylinders cold. MS3 Basic
- 2003 miata, ms3x (braineak) crank no start.
- MSPNP replacing fried fuel pump driver
- Anyone willing to look at my msq and a decent log ? Please
- Microsquirt/DIY Megasquirt 2 question.
- Tuner in South Florida
- MSPNP2 Noob
- What Megasquirt do I have
- 2004 Mazdaspeed miata starts and die with Ms3pnp pro
- 2004 Mazdaspeed miata starts and die with Ms3pnp pro
- installed MSPNP no fuel pump prime- Yes pulled fuse
- NA93 OEM sequential injection .. and MS3 Basic
- 1995 Miata with ODBII which MS?
- DIYPNP + VVT + R8 Coils
- Diypnp2 help
- DIYPNP not reading AFR from AEM WB02
- Tunestudio Warnings
- MS3 Interchangeability
- startup issue. log/settings included
- Car died, Now it seems like there is a short to power
- Ms3x vs Ms3 ultimate- resistors
- MS3x Braineak '03 Miata Crank No Start
- losing power at higher rpm (bucks)
- MS Tuner on LI/NYC area
- High AFRs and dodgy running. Misfire or other?
- Megalog Viewer not letting me run analysis?
- MS Dyno Tuner in the Dallas Area
- erratic afrs under WOT
- Unable to recprd composite log
- Weak spark coil B
- MS3x CAN error
- VICS on MS3Basic
- 1.6 turbo warm start idle issues
- MS3x tuning issue 1.6 turbo
- MSPNP Base timing issues??
- Weird cut offs going through the gears
- Cold AE/tip-in hesitation when cold
- Prebuilt MS3X install questions
- Just got the parts for a MS3X
- Weird idle stall after start hot or cold
- 12v until 2500 rpm - weird idle issues.
- Who do I throw my money at to test a dead MS3X?
- Tune sanity check / second opinion (overly rich?)
- DIYPNP causes extreme rich condition
- Thoughts on base map for 1.6 EV14 Flow Force Injectors 640cc
- 1.8 VVT - MS3 - intermittent lean
- MS2 to 95 Harness
- Link ebc solenoid with ms3x?
- No spark on 1.8 swap
- Turbo miata idle problems
- DIYPNP MX5 fuel pump issues
- NA8 with MS3 intermittently dies
- Iac not changing values
- Looking for ECU pinout and basemap for 1995.5
- Weird idle issues
- DIYPNP NA speedo
- DIY Megasquirt Repair
- Unexplained stalls, unexplained low PW.
- MS3 MSLabs Assistance
- Help getting VVT swap running
- E85 Conversion for 1.6 non-turbo racecar
- Base map not working, rich mixture
- Retard didn't set base timing...How much power was it costing me
- Added IAT sensor now my miata wont start!
- bak bak from the back - ecu or mechanical
- Help 90 going from MS1 to MS3 pro pnp
- Megasquirt MS3X install, only spark on 2 cylinders.
- Diypnp - adding sensor inputs?
- Need some help- AutoTune isnt getting me anywhere close to the Target AF
- Idle is jumping up and down
- 99 miata starts but dies right away
- car running like crap need help
- Wiring Hurts the Brain (LS coils/ID1050 Injectors/Engine Wire harness)
- MS3X Bluetooth capacitors
- Rev MS3 Basic, configuring VICS on NB2
- NB2 running rich mspnp pro
- ITT Knock Vs. Driveline Noise on NB Knock Sensor
- ITT: MS3 1.4.0+ and Closed Loop EBC
- MS2E from NA 1.6 to 99-00 1.8
- MS3 Won't Start
- Do you suffer from FHVS? (Flaccid Homebrew VTPS Syndrome)
- Random Ramp up in Rpm?
- VTPS Wiring Issue.
- Which ECU connector plugs will fit my '95?
- Stock TPS not showing up
- Aled and wled connection terminals?
- help me tune my TPSdot Acceleration Enrichments
- He's knocking on the back door. Should I let him in? How much knocking is okay?
- 99 Idle and Power Issues
- Im a super noob even after reading
- AC issues in 90 when fan set to 2 or higher. 1S?
- Help with IAC valve
- Adding traction control
- Potentially ruined wiring.. need help troubleshooting.
- megasquirt maf delete
- Using Ultragauge with MS3 Basic and OBD2 module
- Converting to MS
- Noob Tries to MS But Fails
- Check out my tune
- Miata hesitation
- MegaLogViever not showing knock
- Name that Megasquirt
- Adding electronic heater control valve
- 99 miata crank but won't start
- crank but no start. Attached composite log
- Car idles for about 5 seconds and leans out
- super miata 36-2 settings
- Car likes to idle at AFR 13.7
- Lock Tunes
- DIYPNP poor start
- Having Issues with Enhanced MS2 features, fuel pump, AC.
- How does the IAC Valve affect the tune at Speed?
- MS3 pro no dash tach NA chassis
- What have I done to my megasquirt
- AC always on
- DIYPNP Noisy TPS Ground issue
- DIYPNP 00 Wonky Sync, no power
- is this megasquirt built correctly
- need help with megasquirt rpm mismatch
- Engine just died in traffic
- 05 + MS3x no power to pin 4AF?
- Ms3 basic - Virtual dyno NB2001 vvt.
- confused about parallel fan wiring... what pertains to me?
- Full time closed loop EGO
- implementing custom ini file
- Ms3pro locked up. No start, no tuner studio.
- MS2 Enhanced - Advanced LC
- ID1000s + E85 + Boost help.
- Car doesn't start with MS3 Basic
- 92 NA6 Miata MSPNP2 after going back to stock injectors
- MAF Fault CEL
- Built 05' MSM motor w/ EUDM intake Base Map?
- DIYPNP Will Not Start My Miata
- MS3X - Finally Runs! But 3 seperate issues
- How adjust map kpa/fuel load
- Voltage creep on Auto 4-Wire TPS
- Upgrading/changing an assembled DIYPNP's map sensor (boosting past 22psi)
- Fuel load kpa reading 98 percent at all times help!
- Spoonfeed an eggplant VVT
- Naturally Aspirated gains with a NB head and DIYPNP ,Tips??
- Wideband reading lean after free-air calibration
- DIYPNP and knock sensing
- MSPNP starts, run, then dies at idle
- AFR is sporadic and wrong between TS and WIDEband
- MS3 Enhanced P0106 MAP Sensor
- Could I have the wrong firmware?
- Air/Fuel Gauge issues
- 22.4 AFR @ Idle
- Could use some help- Noob
- Calling out Braineack and/or Reverent!
- Paid support options?
- Typical Cranking RPM
- Can't figure out this very high idle oscillation after driving
- Launch Control per Trubokitty
- Ready for Roast: New MS3X, New Motor Swap, Newbie Has Problems
- Fresh PnP Megasquirt Install, Car Not Starting
- Looking for guidance on order
- Wrong MAP Reading
- CRC mismatch
- Cant get idle dialed in. Need help
- Anybody Use Det Cans??
- New Fuel Pump, Car won't start
- Adventures in EBC (or, "Conflict with additional injectors PT2/4")
- Burnt transistor in 'Joes better spark output circuit'. Cause?
- oi pressure AND temp sensor
- MS2 Not seeing RPM at startup intermittent
- MS1 Identification Help
- car dies after minutes
- Does anyone have ID1050x injector calibration settings?
- How To: Custom Thermistor Tables
- DIYAutotune CAN-EGT Setup Error
- RPM not synced
- Engine suddenly won't run!?
- Socal (specifically Inland empire) Local tuners or Etuners
- Idle droop and stall
- Idles great but the second I throttle miata stalls
- Need to find MS Tuner in Minnesota
- MS3X VSS input
- No start on first start attempt
- Wideband CAN module settings
- MS3 Fan Strategy?
- Rich on start up