Hello,

I was hoping someone could help me look over my maps before I get back and finish my break in and go to crank the boost and blow my new engine. info for current set up is

96 block (block and head decked .007" total, not sure how much compression I will lose from that)
volvo springs
FF 640cc injectors running at 60 psi base fuel supported by a 255lph DeatschWerks pump
manley rods
weisco 83.5mm 8.5:1 pistons
r8 cops
a megasquirt PNPPRO 3
a kraken top mount with a 6258 and a 3" exhaust
through a 6speed and a 3.6 rear end with a torsen type 2

I am currently running on the low power waste-gate at 7 psi and am tuned up to 10-11 psi for when I turn on the boost solenoid. planned power level is max 17psi or 220 kpa and over boost protection at 230 psi.



thanks for any help