I've searched Google like a bandit and this forum as well. I found this thread where another member was working to get the AM gauge working with the EMU, but I couldn't PM him due to my noobishly low postcount.

So...

Here's the issue. AutoMeter WBO2 gauge outputs a 0v-4v signal. e-Manage is looking for a 1v-5v 0v-5v* input. Finding the right values to put in the EMU wideband setup has so far been an inconsistent hunt-and-peck challenge.

Has anyone successfully coerced these two devices to play nice? Any suggestions would be appreciated.

Thanks.

*EDIT - It's 0v-5v, not 1v-5v. This misunderstanding is what made everything more complex than it needed to be. I'm going to set the gauge output low-high to 10-20 and the emanage wideband settings low-high to 10-22.5 and that should fix the issue. Will confirm if it works.

-SD

 

I can confirm that the settings above work. EMU is up and running.