Notices
Engine Performance This section is for discussion on all engine building related questions.
Sponsored by:
Sponsored by: KPower

Car trys to start then dies. ran at first but now will not

Thread Tools
 
Search this Thread
 
Old Sep 15, 2012 | 01:48 PM
  #1  
90 Turbo's Avatar
Thread Starter
Senior Member
iTrader: (3)
 
Joined: Sep 2011
Posts: 595
Total Cats: -1
From: Plano TX
Default Car trys to start then dies. ran at first but now will not

Ok i changed the radiator and found a spot for my temp sensor. I did not think i messed with anything else. I messed around back by the cas to hook up the dash temp sensor.
its DIYPNP so i reloaded firmware and base map.

after radiator and down pipe removal and new rad installed and downpipe reattached. started the car no problem ran for about 30sec-90sec then died. just all of a sudden died would try and start back run for a second after the key was released even build rpm to 2k or so but not start really.
Came back 10min later started for 30-45 sec then died again.

I changed Cas
coil
battery
afr look fine.
reflashed firmware and reset everything

I am so frustrated.
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
ReallyRottenTurbo
MEGAsquirt
4
Sep 22, 2015 12:49 PM
huesmann
MEGAsquirt
19
Sep 16, 2015 07:11 PM
bigben
Race Prep
16
Sep 11, 2015 03:41 PM
shanesauce
General Miata Chat
1
Sep 6, 2015 08:47 PM
Motorsport-Electronics
ECUs and Tuning
0
Sep 5, 2015 08:02 AM




All times are GMT -4. The time now is 07:43 AM.