I working on a 90' Miata with a Mazdaspeed Miata engine. It has a voodoo II GT2560 kit. I will be running an AEM EMS-4 with Toyota COPs. I am in the process of building the harness. I finished mounting the coils and wiring them. I'll post more pics as I go along.

EB Turbo

 

Raychem = winning.

 

Newb of the ******* year up in hurrrrr.

 

Me? Definately not. Dont be fooled by my low post count.

EB Turbo

 

You clearly know how to build a harness, I am all Smuckers over it.

 

Are those Raychem SCL boots at the ends of the wiring?

 

It is similar. It is 4:1 instead of 2.5:1. Plus it dries a little harder than SCL. The Y transitions are home made from the same material of a larger diameter. The high shrink ratio makes it easy to do. SCL is just heat shrink. It is not a boot. Boots are pretty expensive, anywhere from $10-30 a piece.

EB Turbo

 

Don't see pics...

 

I see them, They are there. They are also on my FB page Chris.

EB Turbo

 

Pics broken for me too.

 

I will repost it tomorrow.

EB Turbo

 

I reposted the image. It should stay up this time.

EB Turbo

 

Indeed. Very nice work.

 

Hi there,

I have a 93 1.8 miata running a megasquirt ecu and a disco potato turbo..

I have just purchased four COP's and the connectors and loom - could you please give me some advice on turning this into a loom for the COP's conversion on a miata do you have a wiring diagram for 93 miata please...

Thanks,

Hal.

 

There are many writeups on how to install COPs in your Miata. You can continue with the wasted spark method and follow the writeup in the link. If your megasquirt is worth anything you should be able find 2 more ignition outputs and run the COPs sequentially. It may take a bit more work and wiring but it will work the best.

https://www.miataturbo.net/useful-sa...writeup-12704/

EB Turbo

 

Welcome to the forum and your wiring looks amazing. I will learn how to make a proper harness one day.

 

Hi - yes sequentially that is what I would like to do - I have the bits just need some advice on where the wires go and how to map the MS Maybe Braineak could help... any help appreciated chap's!!

 

The coil gets 12v, engine gnd and signal from the ECU. There are a few different ways to get power. The MS won need to be remapped. You will just need to enable the extra coil outputs and change the dwell settings. .

EB Turbo

 

That's great thanks EB Turbo - great information. If I am going for plug and play is there a plug I need to buy to wire the cop's loom into? I think I found a link to one but can't find it again now. Going to build my COP's this week..... Cheers Hal.

Sorted this thanks...

 

Errr can I do sequential on a MS1???? or just wasted spark... thanks.