Megasquirt maps for SC
#1
Junior Member
Thread Starter
iTrader: (2)
Join Date: Mar 2008
Location: Largo, FL
Posts: 88
Total Cats: 0
Megasquirt maps for SC
Does anyone have a map for pretty much FM's supercharger kit? Its virtually exactly what I have, and it would be a lot easier to learn megasquirt if I was able to start from a close point. Thanks guys.
#7
Junior Member
Thread Starter
iTrader: (2)
Join Date: Mar 2008
Location: Largo, FL
Posts: 88
Total Cats: 0
thanks guys! I wanted to get this thing installed with my 8psi pulley yesterday and today for the autox next weekend, but..... I ended up getting my wisdom teeth pulled yesterday for funzies... I was like, gosh, go home on friday and just hang out? hah! I think I'll get my teeth pulled...
#11
Junior Member
Thread Starter
iTrader: (2)
Join Date: Mar 2008
Location: Largo, FL
Posts: 88
Total Cats: 0
My mouth still hurts, my wisdom teeth were sideways in the back so it was pretty tough to get them out. My lower jaw is cramping up if I am not on meds.
I don't think I am going to be able to get the megasquirt installed before my next autocross this Sunday. I'm going to have to install the wideband o2, make sure the elf is tuned "ok" and then run it like that. Next weekend I can install the MSPNP and put the 8psi pulley on.
Wheres the best location to mount the wideband o2?
I don't think I am going to be able to get the megasquirt installed before my next autocross this Sunday. I'm going to have to install the wideband o2, make sure the elf is tuned "ok" and then run it like that. Next weekend I can install the MSPNP and put the 8psi pulley on.
Wheres the best location to mount the wideband o2?
#12
My mouth still hurts, my wisdom teeth were sideways in the back so it was pretty tough to get them out. My lower jaw is cramping up if I am not on meds.
I don't think I am going to be able to get the megasquirt installed before my next autocross this Sunday. I'm going to have to install the wideband o2, make sure the elf is tuned "ok" and then run it like that. Next weekend I can install the MSPNP and put the 8psi pulley on.
Wheres the best location to mount the wideband o2?
I don't think I am going to be able to get the megasquirt installed before my next autocross this Sunday. I'm going to have to install the wideband o2, make sure the elf is tuned "ok" and then run it like that. Next weekend I can install the MSPNP and put the 8psi pulley on.
Wheres the best location to mount the wideband o2?
I mounted my WBO2 ~4-6" infront of the cat.
#13
Junior Member
Thread Starter
iTrader: (2)
Join Date: Mar 2008
Location: Largo, FL
Posts: 88
Total Cats: 0
The elf isn't too bad. For a 5psi set up it seems like it would work wonders.
Still haven't installed the MSPNP yet this weekend isn't looking good either. Hopefully next weekend I'll be able to do it.
Still haven't installed the MSPNP yet this weekend isn't looking good either. Hopefully next weekend I'll be able to do it.
#16
heh.... so rich it doesnt register on the gauge
Need to do some street tuning again one of these nights.
Hopefully a dyno soon after.
But it's tuned enough that I put 4 car lengths out on the street on some goofballs in a white lowered integra with "rimz yo" and the dorks had matching white hats...
-meaty
Need to do some street tuning again one of these nights.
Hopefully a dyno soon after.
But it's tuned enough that I put 4 car lengths out on the street on some goofballs in a white lowered integra with "rimz yo" and the dorks had matching white hats...
-meaty
#18
Junior Member
Thread Starter
iTrader: (2)
Join Date: Mar 2008
Location: Largo, FL
Posts: 88
Total Cats: 0
What kind of MS are you running? Get the appropriate map for you system, and if you are running a m45 with 8psi, you'll be pretty close. Timing shouldn't need to be adjusted at all, and you will need to change your fuel map a little to adjust. my car is at 5psi (on the 62 though) and I had to take about 15 off my fuel on the upper end, and 10 on the lower end to get the car to run where I wanted it.
#20
Junior Member
Thread Starter
iTrader: (2)
Join Date: Mar 2008
Location: Largo, FL
Posts: 88
Total Cats: 0
Dave, my car runs absolutely perfectly, until I turn on the a/c. Then its pretty much hit or miss. I'll post it up, as I am sure there are people who going to be using the similar set up without a/c.
stock injectors
WITH MAF
5psi pulley, 10 degrees base timing.
i'll post it up this evening or on the way home.
stock injectors
WITH MAF
5psi pulley, 10 degrees base timing.
i'll post it up this evening or on the way home.