Currently doing a depower on my 2001 miata.
I have removed the snap ring and valvebody off of the pinion, but now there is a rubber seal, metal washer, bearing, and three pronged metal stopper left on the pinion. I haven't seen any picture or explanation on how to remove these from the pinion, can someone illuminate the situation please? I'll post a picture in a couple minutes. I need the pinion (correct me if this is wrong) to be free of the seal and bearing so they dont get damaged when the pinion is welded. |
|
How do i remove that pin? Do i hammer it down? I dont need it anymore, since it holds the valve body in place, and I no longer have the valvebody. I need this advice as soon as possible, I have to be at the welder in an hour.
|
Originally Posted by thumpetto007
(Post 1405745)
How do i remove that pin? Do i hammer it down? I dont need it anymore, since it holds the valve body in place, and I no longer have the valvebody. I need this advice as soon as possible, I have to be at the welder in an hour.
|
I have seen a picture like that too, but I'm still at a loss of how to remove the bearing or seal.
There is a machined, gapless, three pointed clip holding the bearing on the worm gear side. |
|
All times are GMT -4. The time now is 07:12 PM. |
© 2024 MH Sub I, LLC dba Internet Brands