Neutral saftey and Back up light switches - locating and wiring.
6 Attachment(s)
So I've found that neither of these switches are hooked up in my car. I looked under the car and nothing is hooked up because all the connectors are completely different. Based on my research so far, it looks like the previous owner swapped in a later model transmission in my '92I have two switches on the drivers side of the transmission like this:
https://www.miataturbo.net/attachmen...ine=1322592657 On the harness there were two female bullet connectors which based on research seems to be for the back up light switch which I cut off. Those connectors can be seen at the top of this older trans https://www.miataturbo.net/attachmen...ine=1322592657 https://www.miataturbo.net/attachmen...ine=1322592657 These are the connectors I have - i chopped off the two female bullet connectors and was going to splice them into one of the switches but I figured I would ask before. They are the two wires electrical taped on the right, then I only have one single wire coming out with a white connector at the furthest - am I missing a wire for the neutral safety switch? If switches need replacing are they the same switch for both? https://lh5.googleusercontent.com/-G...0/IMAG0197.jpg |
The sensors should be in the same place on the trans but you could easily check with a multimeter and shifting the trans into reverse.
|
Or just in neutral. The switch that is closed is reverse, the open one is reverse. |
it seems like i'm missing a wire for the neutral safety though?
|
All times are GMT -4. The time now is 05:07 AM. |
© 2024 MH Sub I, LLC dba Internet Brands