Noob question on Fidanza flywheel?
 

Just picked up a used fidanza flywheel for my 1.8. Also, picked up an ACT HD clutch kit. New to lightweight flywheels for the most part so I'm just curious, why are the steel faces replaceable? Do you have lightweight flywheels machined like regular/OE flywheels or is that what the replaceable face is for? Tried doing some research on this to no answer, just found thousands of places and forums to buy them.

Inform please?

It's so you dont have to take it to a machine shop to get it resurfaced.

[martha stewart] It's a good thing [/martha stewart]

P.S
It says that right on their website

The friction rings are only good to be resurfaced a few times, and having them replaceable allows you to swap it when its too worn.

Ahh ok, well buying this used from a person/car I have no prior history of, I figured it was best to have it machined but from the 2nd poster's opinion I don't need to? Surely I shouldnt just throw it back in with the new clutch and figure all is well correct? I just know from my commercial side of all this is that when we do a clutch job or for any reason take loose a flywheel we send it immediately to the machine shop for machining if applicable. Being an aftermarket lighweight hence be the reason I figured I would ask some more performance experienced minds.

They can be machined. A used one SHOULD be machined before it's installed unless there isn't enough face left to machine. New friction plates are about $50. If machining costs about the same, just buy new.

I found out the hard way that there were two different friction rings for the Miata Fidanza flywheel, an 18-bolt and a 20-bolt. Make sure you get the right one if you get a new one. In fact, I have an 18-bolt ring, still brand new in the plastic, I think it even has new mounting hardware, that I'd ship to you for $45.

Damn awesome, if it doesnt sell Ill be getting that from you! Anybody describe driving on one? Never owned/drove a car with a lightweight flywheel

I love my fidenza in my na 1.8. It transforms the car.

It's just sitting in my garage. Let me know when you want it and I'll send you my PayPal information.

The revs fall a bit faster, and it revs more responsively.

You'll also get lots of tranny noise any time you engine brake.

i have this flywheel in my 1.6L and i love it, got it used with my first Miata and replaced the friction surface when i changed the clutch. I also have an ACT HD clutch kit in there. I love how quickly the engine revs, but when downshifting you def. gotta blip the throttle to keep the rpms up for a smooth shift. I feel it's worth the money.

What do you guys think of using the Fidanza fly with an OEM clutch/PP? I don't want extra stress on the clutch hydraulics (had to replace CMC and slave once, and read of other ppl having to replace them every 3 months or so). I was going to use Clutchnet's organic unsprung w/ an OEM PP, but have also read bad things about Clutchnet, which makes me just get an OEM clutch. Stock 1.6L power, probably don't need much more... I do go to the track though, but the clutch I have in there now takes the track abuse just fine.

I'm running an ACT HD/street on a 10lb Fidanza in the rental and it's awesome. I am actively looking for a 1.6 version of the same clutch, though, so I can swap the flywheel with the 7lb version sitting in the garage.

what you need is the 7.25 version of the fidanza and a lightly used twin plate clutch... wink wink.

My intended setup was in hopes to use the Fidanza 1.6L fly you are (were?) selling. Looking for a close to OEM pressure plate so as not to stress out the slave and master cylinder too much-- or is this something I shouldn't worry about?