90-93 Toyota COP mounting plate
I'm in the market for a 1.6L miata Toyota COP mounting plate. I have seen a lot of you guys had several lot cut on water jet, so I was wondering if anybody had an extra lying around they would like to sell?
|
Cant make one? I thought most of us cut them with a drill and hack saw.
|
I've never seen any waterjetted, but ours are stamped out of 1/8" aluminum with studs pressed into place. I've yet to see a cleaner solution.
Shoot me a PM with a Paypal address and I can invoice you for one - they are $50 shipped in the lower 48 states. |
You've never seen a waterjetted one? Have you read through the 69 page cop thread? Lol, I scan through the thread to look for images. A few guys have had a few sets water jetted. I can make my own with a hole saw, I was looking for something cleaner.
|
Originally Posted by JEMERY
(Post 688383)
You've never seen a waterjetted one? Have you read through the 69 page cop thread? Lol, I scan through the thread to look for images. A few guys have had a few sets water jetted. I can make my own with a hole saw, I was looking for something cleaner.
And are these the "water jetted" brackets you have seen? http://trackspeedengineering.com/pho...43_yddhw_0.jpg http://trackspeedengineering.com/pho...44_txczu_0.jpg |
Something cleaner that's going to be covered up? You can see only one cut edge on mine (same design as above) where I cut it to length. If you can't do that cleanly you have problems.
And watch your attitude. |
My apologies for offending anyone, I skimmed through the 69 page thread like I said. I just bought one from someone so thanks. Close the thread please.
|
All times are GMT -4. The time now is 03:46 AM. |
© 2024 MH Sub I, LLC dba Internet Brands