Brp supercharger DAMPENER
 

Looking for the damper that goes under the brp mp62. It was some heim joint contraption with a big rubber disk. Or if someone knows where to buy new that would work too. Thanks!

Dampener is something that gets things moist. Damper is something that damps vibration.

Edited info but subject is stuck. I always mix those two words. And you had my hopes up when I saw I had a reply :)

Fast Forward superchargers sell the brackets for the MP62 so they may have the dampener too. I'd send a message to Tom over there ask.

Appreciate it. Yah I emailed and talked with Tom and he doesn’t have it. He said he thought it was a commercially available piece though didn’t know from where.

Can't help you dimensionally but here's a pic off the kit I sold a few years ago. It can be put together from hardware store stuff and a couple readily available heim ends. The "damper" really just seemed to be a hockey puck with a double ended stud through a threaded hole in the middle. Hope it helps. If you have the other parts you can scale things to get close enough.

https://cimg6.ibsrv.net/gimg/www.mia...786e097442.jpg

Thank you. That will
help. Another guy on here has fed me some good info too so I should be able to make one if all else fails.

That rubber disk looks a lot like a transmission mount. A bmw trans mount might work bit its a bit thicker than that.

Another pic for you. I have not installed my system yet so if you need something measured or better pics just PM me.

https://cimg5.ibsrv.net/gimg/www.mia...8a3cb45f57.jpg